Motorola GP68, Руководство по обслуживанию

Страница: 43 / 85

March, 1997 6881086C09-O
4-3
GP68 Portable Radios Service Manual Radio Programming Information
Option Board Setup Mode
The slave radio displays the following message
(Figure
4-4) while it is being programmed.
NOTE
If battery level is low, the slave radio will dis-
play
, and you will need to replace or
recharge the battery before repeating the pro-
cedure.
When cloning is completed, both radios will reset auto-
matically.
Disconnect radios from the cloning cable. They are now
ready for operation.
Error Conditions
An error may occur when cloning a radio. When this hap-
pens, an error message is displayed. Table 4-1 lists the
causes and the possible solutions for each error message.
Figure 4-4 .
5 6
7
Table 4-1Cloning Error Messages
Error Message Problem Solution
Err.01 Incompatible software options error. Cloning from the master radio to the slave radio cannot be
performed.
Err.02 Timeout error
a. The cloning cable connection is not
properly connected or slave radio is
not turned on.
b. Communication between the two ra-
dios is disrupted during the cloning
process.
a. Check the cloning cable connection and also verify that
the slave radio is turned on.
b. Check the cloning connection and all other connections.
Err.03 Master radio checksum error Although the master radio may still function, it should be
serviced by a dealer.
Err.04 No Programmed Channels Error a. If this occurs on the slave radio, repeat cloning procedure.
If it persist, the radio must be serviced by a dealer.
b. If this occurs on the master radio, the radio must be ser-
viced by a dealer.