Motorola GM1200E, Руководство по установке

Страница: 17 / 36

Radio Mounting
Radio Installation 1-11
To fit the remote back housing:
1. Connect the flex to the control head back housing PCB (i.e. original PCB inside control head).
2. Press the control head onto the remote back housing until it snaps into place.
Figure 1-9 Control Head Remote Mount Kit.
To install the remote control head into the vehicle:
1. Position the remote mount bracket in the desired location and mark the positions of the
mounting holes, centrepunch the marked spots and drill a 4 mm Ø hole at each mark. Mount
the trunnion with the supplied screws.
2. Ensure the socket gaskets are in the back of control head and radio front housing and
connect the remote mount cable to both connectors.
3. Snap the control head into the mounting trunnion and fix it with the wing screws.
For more information on the remote mount kit please refer to the accessory chapter in the
Basic Service Manual (section 5 of the Product Manual).
Remote
mount
radio
Remote cable
Remote Controlhead
back housing
Front housing PCB
Controlhead
Gasket
Controlhead
Gasket for
Remote cable socket
Bracket
Remote mount
Flex connector
Flex connector
interface
PCB
Controlhead
Gasket
Remote mount
Radio front housing
Pad
Remote Back Housing
Remote Front Housing