Motorola GM Series, Руководство по обслуживанию

Страница: 21 / 28

Notes For All Schematics and Circuit Boards 2-5
5.0 Notes For All Schematics and Circuit Boards
* Component is frequency sensitive. Refer to the Electrical Parts List for value and usage.
1. Unless otherwise stated, resistances are in Ohms (k = 1000), and capacitances are in picofarads
(pF) or microfarads (µF).
2. DC voltages are measured from point indicated to chassis ground using a Motorola DC
multimeter or equivalent. Transmitter measurements should be made with a 1.2 µH choke in
series with the voltage probe to prevent circuit loading.
3. Interconnect Tie Point Legend:
16_8MHz 16.8MHz Reference Frequency
3V3 Regulated 3.3V Supply Voltage for Voice Storage
5V Regulated 5V Supply Voltage for RF Circuitry
5V Regulated 5V Supply Voltage (Control Head)
5V RF Regulated 5V Supply Voltage for RF Circuitry
5V SOURCE 5V Signal to Switch On Control Head
5VD Regulated 5V Supply Voltage for Digital Circuitry
9V3 Regulated 9.3V Supply Voltage
9V3FLT Filtered 9.3V Supply Voltage
A+ 13.2V Supply Voltage
ADDR *P Address Lines
AN Analog Lines to Analog to Digital Converter
ANALOG INPUT 2 External Keypad Matrix Column Signal
ANALOG INPUT 3 External Keypad Matrix Row Signal
BATTERY VOLTAGE Battery Voltage Sense Line
BL A GREEN Back Light Anode Green
BL A RED Back Light Anode Red
BL GREEN Green Back Light Control
BL K GREEN Back Light Cathode Green
BL K RED Back Light Cathode Red
BL KP Green Green Keypad Back Light Control
BL KP RED Red Keypad Back Light Control
BL LCD GREEN Green Display Back Light Control
BL LCD RED Red Display Back Light Control
BL RED Red Back Light Control
BOOT CNTRL Bootstrap Mode Enable Signal
BOOT MODE Boot Mode Select
BOOT PWR ON Control Head Switch On Signal
BOOT SCI RX Serial Communication Interface Receive Line
BOOT SCI TX Serial Communication Interface Transmit Line
BOOT VPP Boot Mode Select
BUS+ Bi-directional Serial Communication Line
BWSELECT Signal to select between the Ceramic Filter Pairs