![background image](http://html.mh-extra.com/html/motorola/dct5100/dct5100_installation-manual_242101038.webp)
Installation 3-15
DCT5100 Installation Manual
When multiple OOB frequencies are used, the DCT5100 pauses 40 seconds on each valid
frequency. The LED displays
dl
and a progress indicator, which identifies a software object
download. The progress indicator, or crawling ant, moves one position around the dl display
for each segment of download received. If the
dl
stops moving up and down on the LED for
an extended period of time, contact the headend operator.
The progress indicator usually moves at a consistent rate as segment downloads are
received. If all the segments are retrieved in the first pass, the
EF
,
AU
and
FP
messages are
displayed on the LED. If segments are dropped, the progress indicator appears to stall and
then inch forward after the dropped segments are retired.
When the progress indicator alternates between rapid and sluggish movement, this may
indicate that the stream is spinning too fast for existing plant conditions.
The LED displays
EF
for up to 60 seconds when the software object download is complete
during flash erasure and then displays
FP
for up to 60 seconds during flash programming.
The DCT5100 is ready for initialization by the headend controller when the LED display is
blank. Verify that the DCT5100 is powered up or reset within two minutes of a completed
download.
Boot Cycle Error Codes
If hardware or software problems occur, the DCT5100 displays error codes on the LED display.
Table 3-2 is a list of error codes that can occur during boot cycle startup:
Table 3-2
Error codes at boot cycle startup
Error
Code
Description
When error occurs
Action Required
Eb 01
Object failed validation
After the LED displays
dl,
indicating
validation check failed
Contact headend
operator
Eb 02
Download time-out
After cycling twice through the OOB
frequencies
None
Eb 03
Flash erase failed
After software object download complete
and
EF
is displayed
Replace DCT5100
Eb 04
Flash programming
failed
After software object download complete
and
FP
is displayed
Contact headend
operator
Eb 05
Invalid DLC frequency
After the LED displays
dl,
indicating
validation check failed
Contact headend
operator
Eb 06
Hardware initialization
failed
After plugging the DCT5100 into an
electrical outlet to begin the boot cycle
Replace DCT5100
Eb 07
Object failed validation
After software object download complete
and
FP
is displayed
After a successful software object
download and DCT5100 is reset
Contact headend
operator
No action required
because DCT5100
repeats software object
download process
Eb 08
Reserved
None
Содержание DCT5100
Страница 81: ...495014 001 05 02 MGBI ...