Motorola DCT3400 Series, Руководство пользователя

Страница: 40 / 48

34
Connecting the IR Blaster
To connect the IR Blaster:
1
Fit the transmitter into the mounting bracket (refer to Figure 2-3).
2
Plug the mini-pin connector into the ir jack on the rear panel:
Figure 2-4
IR Blaster installed
3
Remove the adhesive tape cover from the mounting bracket.
4
Position and press firmly to attach the mounting bracket to the IR
receiver on the VCR. Be careful to route the wire so that it does not
prevent loading tapes.
Checking the IR Blaster
The IR Blaster is now located near the receiver and the VCR can be
controlled through the cable terminal. As a final check, operate the VCR
using the remote control from various positions in the room. If the IR
Blaster is obstructing the IR receiver on the VCR, move it slightly.