Motorola CDR500, Руководство по программированию

Страница: 77 / 104

March, 2001 6864110R66-O
10-3
CDR500 & CDR700 Repeater Service Manual Programming the Professional Series Radios for use with a i20R Repeater Controller
Programming
11. Click on the “Accessory Mic Gain (dB)” up
arrow button to increase the gain to “31.5”.
Your
screen should appear similar
Figure 10-6.
12. “Close” the “Radio Configuration” window.
13. Click the + indicator next to “Conventional
Personality” selection from the opening CPS
“Tree View” window.
14. Double click the “Conventional Personality - 1”
selection.
15. Select the “Basic” tab.
16. If the radio is a display model (LCD front
panel), you may enter an “Alias” that will be
displayed such as “Repeater Tx”.
17. Select a “Channel Bandwidth (kHz):” as
defined by the radio licensing authority.
NOTE
In the United States of America, the
Professional Series radios may not
legally be used as the transmit radio in a
UHF (450 to 512 MHz) repeater or base
station application with 12.5 kHz chan-
nel spacing. The
±
2.5-ppm frequency sta-
bility capability of the radio does not
meet the requirements of Part 90 of the
Rules and Regulations of the Federal
Communications Commission (FCC). In
other countries, check local frequency
stability requirements before placing a
Professional radio based repeater or base
station in operation.
18. Enter the transmit frequency for the repeater
in the “Rx” area at “Frequency (MHz)”.
19. Select the “Squelch Type:” as “CSQ” (Carrier
SQuelch).
20. Enter the transmit frequency for the repeater
in the “Tx” area at “Frequency (MHz)”.
21. Select the “Squelch Type:” as “CSQ” (Carrier
SQuelch). Your screen should appear similar
to Figure 10-7.
22. Enter any other special programming require-
ments in the appropriate windows.
23. Assign the personality to a zone in the “Per-
sonality Assignment to Zone” selection win-
dows.
24. Program the transmit radio.
i20R Campus Repeater Panel
i20R Programming
Use the information available in the i20R RSS Manual,
6880904Z55, to program the interconnecting jacks,
repeater parameters and user parameters.
Figure 10-5. Radio Configuration, Accessory Pins,
Transmit Radio
Figure 10-6. Radio Configuration, Microphone,
Transmit Radio