Motorola BSR 2000, Руководство по настройке и управлению

Страница: 39 / 650

Release 1.0 Using the Command Line Interface
526360-001-00 Rev. B MGBI 2-7
To exit PacketCable Configuration mode and return to Global Configuration mode,
enter the
exit or end commands. To exit PacketCable Configuration mode and return
to Privileged EXEC mode, press Ctrl-Z .
IPSec Configuration Mode
IPSec (IP Security) Configuration mode is used to configure a security policy that
protects network traffic between two IPSec peers. The following command example
shows how to enter IPSec Configuration mode from Global Configuration mode:
MOT
(config)#
ipsec < Enter >
MOT
(config-ipsec)#
To exit IPSec Configuration mode and return to Global Configuration mode, enter the
exit or end commands. To exit IPSec Configuration mode and return to Privileged
EXEC mode, press Ctrl-Z .
Router Configuration Mode
Router Configuration mode is used to configure BGP, OSPF, PIM, and RIP routing
protocol features. From Global Configuration mode, enter Router Configuration
mode by entering any
router command. The prompt changes in relation to the
specific protocol. (refer to Table 2-2 .) The following command example shows how
to enter Router Configuration mode for RIP from Global Configuration mode:
MOT (config)#
router rip < Enter >
MOT
(config-rip)#
To exit Router Configuration mode and return to Global Configuration mode, enter
the
exit or end commands. To exit Router Configuration mode and return to
Privileged EXEC mode, use the end command or press Ctrl-Z .
Route Map Configuration Mode
Route Map Configuration mode is used to establish route maps with the conditions for
redistributing routes from one routing protocol to an another. The following command
example shows how to enter Route Map Configuration mode from Global
Configuration mode:
MOT (config)#
route-map <
WORD
>
MOT
(config-rmap)#
(
WORD
= the name of the route map)