Motorola BSR 2000, Руководство по настройке и управлению

Страница: 35 / 650

Release 1.0 Using the Command Line Interface
526360-001-00 Rev. B MGBI 2-3
Using a Telnet Session to Access the CLI
This section describes accessing the CLI by establishing a telnet session to the BSR.
To establish a Telnet session with the BSR, do the following:
1. Start the telnet application. Enter the host name or the IP address of the BSR in
the appropriate field or system prompt.
2. Press Enter . The following prompt displays:
MOT
>
3. Enter the following command:
MOT >
enable
This brings you to Privileged EXEC mode. A
Password:
prompt displays.
4. Enter the password and press the Enter key to access Privileged EXEC mode.
The
MOT
#
prompt displays.
5. To terminate the Telnet connection and exit the Telnet application, enter exit at
the prompt in Privileged EXEC mode.
For a detailed discussion of the different command line modes, refer to the CLI
Command Modes section.
CLI Command Modes
The command line interface is organized into different command modes. Each
command mode has its own set of commands available for configuring and
monitoring the BSR and network operations.
Table 2-2 provides details on entering
each command mode, the prompt display, navigating through the command mode
hierarchy, and exiting each command mode.
■
EXEC command line interface modes are used to navigate the CLI and perform
basic BSR startup, configuration, and monitoring tasks. The EXEC modes are as
follows:
Note: If an IP address has not been configured for the Ethernet interface and
a password has not been configured for the BSR, you can not access the
BSR through telnet. Refer to
Chapter 3 for information on setting system
passwords and telnet parameters, and Chapter 5 for information on
configuring an Ethernet interface.