9
Message Slot Number: At the end of each message, pre-
ceding the time stamp, the message slot number is dis-
played to indicate the order in which the message was re-
ceived. (Example:
09 10:30a
: the 09 indicates the ninth
message received.)
Erase All: All read, unlocked messages can be deleted
from memory using the “Erase All” function.
Backlighted Display: Press the On/Off Switch for back-
lighting in low-light conditions.
Freeze Screen: When reading a message, you can
“freeze” it on the screen by pressing and holding
R
.
SILENT: When in the SILENT mode, the pager does not
give an audible alert.
CLEANING YOUR BRAVO PLUS PAGER
To clean the exterior of the BRAVO PLUS pager, use a
soft, non-abrasive cloth moistened in a mild soap and wa-
ter solution. Use a second cloth moistened in clean water
to wipe the surface clean. Do not immerse in water. Do not
use alcohol or other cleaning solutions.
REPAIR AND MAINTENANCE
The BRAVO PLUS n umeric display pager, proper ly han-
dled, is capable of many years of trouble-free service.
However, if service is required, Motorola's National Service
Organization, staffed with specially trained technicians, of-
fers strategically located repair and maintenance facilities.
Consult your Motorola sales representative for service lo-
cations in your area.
10
BATTERY INFORMATION
Your BRAVO PLUS pager is designed to operate with a
single AA-size alkaline battery.
Installing/Replacing the Battery
• Locate the ribbed lock on the bottom of the pager. Slide
the lock toward the back cover to expose the red marking.
• While pressing on the recess of the battery door, slide
the door in the direction of the arrow until it pops up from
the housing.
• Align the battery so the polarity markings (+ and -) match
the markings on the back cover. Insert the battery.
• Align the semicircle on the battery door with the semicircle
on the bottom of the pager near the word “LOCK”. Press
down on the end of the door nearest the battery and slide
the battery door until it is completely closed.
• After the cover is closed, slide the lock toward the front
of the pager to conceal the red marking.
Low-Battery Indicator
When the battery nears the end of its life, the standby
screen is replaced with
lo cell
. The battery must be re-
placed within a few days to avoid interruption of pager op-
eration.
DIAGRAM
LOCK
BATTERY DOOR
(+)
(–)
11
PATENT INFORMATION
The BRAVO PLUS and BRAVO PLUS Auto Synthesized
pagers are manufactured under one or more Motorola U.S.
patents. A partial listing of these patents can be viewed on
the back cover upon removal of the belt clip. Other U.S
patents for these products are pending.
REMOVING THE BELT CLIP
Position the pager so that the display faces you. Rotate the
pager until the belt clip is pointing up (
R
and
F
buttons
pointing toward the ground). Hold the belt clip in one hand.
Use your other hand to push down on the small black
spring-loaded tab (located between the two metallic tabs
on the pager housing) with either your finger or a coin.
With this tab held down, slide the belt clip toward you until
it is free of the housing.
t
, Motorola, and
BRAVO PLUS
are trademarks or registered
trademarks of Motorola Inc.
1991-1995 by Motorola, Inc., Paging Products Group
1500 Gateway Boulevard, Boynton Beach, FL 33426-8292
All rights reserved.
Printed in U.S.A. 3/95
@6881012B23@
6881012B23-D
