The user login feature enables the recipient of your message to identify you as the sender by assigning
a username to your message. It also supports query authentication requirements so the query service
knows which user originated a query.
Two-Factor Authentication allows you to address a specific user of the radio when sending messages
so the message is delivered to the user, and not anyone else who may have been using the radio at
the time.
Your user name, unit ID, and password must be provisioned in PremierOne
™
. Your user account in
PremierOne must be linked to an ARS account specifying a token to be used with the Two-Factor
passcode.
You can upgrade the Single Factor session to a Two- Factor session by entering the Two-Factor
passcode only. After an interruption, for example mode change, Dynamic System Resilience (DSR)
switch over, or power loss, the radio is able to restore the active session in its current state as long as
the session is active in the server.
6.14.1.1
Logging in using the Two-Factor Authentication
Procedure:
1
Perform one of the following actions:
• Press the preprogrammed
User Login
button.
•
or to
User
, and press the
Menu Select
button directly below
User
.
The display shows the
User Login
screen.
2
Perform one of the following actions:
•
or
to
[ID Entry]
and press the
Menu Select
button directly below
Edit
. A
blinking cursor appears. Use the
keypad
to type or edit a username. Press the
Menu Select
button directly below
Ok
to submit.
•
or
to scroll through the list of predefined usernames. Press the
Menu Select
button
directly below
Sel
to select the predefined username.
• Press and hold
or
to scroll through the list of predefined usernames at a fast scroll
rate. Press the
Menu Select
button directly below
Sel
to select the predefined username.
If the selected predefined username has more than the maximum allowed characters, or an
invalid character in it, the display shows momentary
Invalid ID
.
3
For radio enabled with Unit ID, perform one of the following actions:
•
or
to
[UnitID Entry]
and press the
Menu Select
button directly below
Edit
. A
blinking cursor appears. Use the
keypad
to type or edit a Unit ID. Press the
Menu Select
button directly below
Ok
to submit.
•
or
to scroll through the list of predefined Unit IDs. Press the
Menu Select
button
directly below
Sel
to select the predefined Unit ID.
• Press and hold
or
to scroll through the list of predefined Unit IDs at a fast scroll rate.
Press the
Menu Select
button directly below
Sel
to select the predefined Unit ID.
If the selected predefined Unit ID has more than the maximum allowed characters, or an invalid
character in it, the display shows momentary
Invalid UnitID
.
4
Enter your password when you see a blinking cursor.
MN003110A01-AJ
Chapter 6: Advanced Features
69
