CAN Interface
MOTOROLA
Technical Summary
2-19
2.12 CAN Interface
The 56F8323EVM board contains a CAN physical-layer interface chip that is attached to
the FlexCAN port’s CAN_RX and CAN_TX pins on the 56F8323. The EVM board uses a
Philips high-speed, 1.0Mbps, physical layer interface chip, PCA82C250. Due to the +5.0V
operating voltage of the CAN interface chip, a pull-up to +5.0V is required to level shift
the Transmit Data output line from the 56F8323. The CAN_TX and CAN_RX signals
from the processor can be isolated by the connector at JG15; see
. The CANH
and CANL signals pass through inductors before attaching to the CAN bus connectors. A
primary, J12, and daisy chain, J13, CAN connectors are provided to allow easy
daisy-chaining of CAN devices. CAN bus termination of 120 ohms can be provided by
adding a jumper to JG10. Refer to
for the CAN connector signals and to
for a connection diagram.
Figure 2-10. CAN Interface
.
Table 2-12. CAN Signal Isolation Jumper Options
JG15
Pin #
Signal
Pin #
Signal
1
CAN_TX
2
CAN_TX to CAN Transceiver
3
CAN_RX
4
CAN_RX from CAN Transceiver
56F8323
+5.0V
CAN Transceiver
J12
Daisy Chain CAN
Connector
J13
CAN Bus
Connector
CAN Bus
Terminator
JG10
120
PCA82C250T
1K
CAN_TX
CAN_RX
1
2
3
4
5
4
3
5
CANH
CANL
TXD
RXD
JG15
1
3
4
2
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
.
..