Motorola solutions Avigilon 12.0W-H5A-FE-DC1, Руководство по установке

Страница: 21 / 72

If the camera is installed outdoors, it is important that the cables be insulated against the weather. Provided
with the camera are two rubber grommets for waterproofing the required cables:
l
Use the single-hole rubber grommet for installations using PoE power and require only the Ethernet
cable. For more information, see
Inserting an Ethernet Cable through the Single-Hole Grommet
below .
l
Use the 3-hole rubber grommet for installations that require more than one cable. For more
information, see
Inserting Cables through the 3-Hole Grommet on the next page .
Inserting an Ethernet Cable through the Single-Hole Grommet
You must pull the required Ethernet cable through the single-hole sealing grommet included with the
camera.
1. Remove the sealing grommet from the accessory kit.
2. Pull the tab on the grommet to open a hole for the Ethernet cable.
3. Push an Ethernet cable through the grommet by one of the following methods:
a. If the Ethernet cable is uncrimped, push the cable through the grommet.
b. If the Ethernet cable is already crimped, place the grommet piercing cap on the Ethernet
connector then push the cable through the grommet.
Ensure that the orientation of the cable and grommet matches the one shown in the image.
c.
Note: If you require multiple cables, see Inserting Cables through the 3-Hole
Grommet on the next page to follow the 3-hole grommet procedure.
Inserting an Ethernet Cable through the Single-Hole Grommet 14