5A
5B
90°
3
2
C
A
B
2
1
4
EN
EN
Position the turnstile in the desired
location and drill holes in the ground,
according to the fixing plates in each
lower corner of the turnstile.
Before positioning the turnstile structure,
run the power cable through one of the
side bars.
Insert the bushings (x2), nuts (x2) and
screws (x2) into the holes in each leg.
Tighten with a wrench.
To access the control board, remove the
top plate from the turnstile with the help
of one person.
Fit the rotation axis to the opening on the
underside of the ceiling.
Fix the rotation axis to the ground:
A
• Lift the protective sleeve;
B
• Drill holes through the holes in the
rotation axis base;
C
• Insert the bushings (x2), nuts (x2) and
screws (x2) into the holes and tighten.
• INSTALL TURNSTLILE
• SECURE ROTATION AXIS
Make sure that the rotation axis is
exactly 90 ° aligned with the ground.
03. INSTALLATION
03. INSTALLATION
PRE-INSTALLATION
INSTALLATION
• The floor on which the turnstiles are to be mounted must be completely flat and balanced.
• Installations should not be made if there are bumps and slopes on the floor.
• The assembly must not be done on unstable floors (example: soil, sand, gravel, plaster).
• There must not be installation or wiring under the floor where the tourniquet will be installed (If it is
not possible to fulfill this requirement, the installation must be specified according to a project).
• No dust should enter the holes when mounting the turnstile on the floor.
• If possible, remove dust with a pneumatic hose or similar tools.
• Turnstile users must not open the mechanism. Maintenance and repair work should only be carried
out by specialized personnel. Unconscious interventions can lead to dangerous situations for the
mechanism and for the user
• Turnstiles must be protected against any type of shock and vibration.
• Do not insert any voltage beyond the values specified in the technical characteristics of the turnstile.
• Do not exceed the relative humidity and operating temperature values specified in the technical
characteristics of the turnstile.
• Check all connections and verify that they are correct before supplying power to the turnstile.
• Do not use any equipment on the turnstile other than the hardware and parts provided by the producer.
• Disconnect the power supply in the event of an electrical failure in the turnstiles. Please contact the
supplier directly without intervening in the product.
• Make sure the power was cut before proceeding to the maintenance / cleaning the turnstiles.
• The inside of the turnstile must not come into contact with water. Do not use the turnstile in high
magnetic fields.
• The turnstile cannot be stored or operated in a humid environment.
• Do not continue to use your turnstile if it is damaged or defective. Contact us and inform
• the technical service of the product without delay.
• Do not allow children or unauthorized persons to play with the turnstile.
GROUND PREPARATION
1
2
3
4
5
6
