1
Rev. 1.0 07/05/2010
In case it is necessary to reset the device to default factory set-
tings, press the SEL and SET keys together so that all indica-
tor LEDs switch on and then immediately off at the same time.
I
MPORTANT FOR THE INSTALLER
The product does not have any type of isolating device for
the 230 Vac line. It will therefore be the responsibility of the
installer to arrange an isolating device inside the plant. It must
be positioned where it can be protected from accidental clos-
ing, according to that prescribed in point 5.2.9 of EN 12453.
Wiring of the various electrical components outside of the
product must be carried out in compliance with that pre-
scribed in Standard EN 60204-1 and its amendments at point
5.2.7 of EN 12453. Power supply and connection cables
must be fixed using the cable glands that can be supplied as
an optional.
Pay attention while making holes in the outside casing, when
passing cables for connection and power supply and assem-
bling the cable glands, that everything is installed in a way
that keeps IP protection characteristics of the panel un-
changed as much as possible.
Pay careful attention when fastening the cables so that they
are anchored in a manner that is stable.
The back casing is not equipped with suitable predisposi-
tions for fixing to a wall (predisposition for holes for fixing us-
ing anchors or holes for fixing using screws). Plan and im-
plement necessary solutions to achieve an installation that
does not alter the IP protection.
I
MPORTANT FOR THE INSTALLER
- ATTENTION: keep this instruction manual and respect the
important safety prescriptions contained herein. The non com-
pliance with the prescriptions may cause damages and serious
accidents.
- The device must never be used by children or persons with
reduced physical-psychological abilities, unless supervised or
trained on the functioning and the use modalities.
- Frequently examine the plant to detect any signs of damag-
ing. Do not use the device if a repair intervention is necessary.
Attention
All operations which require the opening of the casing (cables
connection, programming, etc.) must be carried out by expert
personnel during installation. For any further operation which
requires the casing to be re-opened (re-programming, repair or
installation amendments) contact the after-sales assistance.
STATEUROP
declares that the products
MSC50 - MSC50 230V
comply with the specifications of the Directives
LVD 2006/95/EC, EMC 2004/108/EC.
