4
Rev. 1.2 31/01/08
F
OR THE
U
SER
-
I
MPORTANT
- The device should not be used by children or by individuals
with reduced physical or psychological abilities unless supervi-
sion is provided or instruction given on how to operate it.
- Do not let children play with the device; keep radio controls
out of their reach.
- CAUTION: Keep this instruction manual in a safe place and
adhere to the important safety instructions contained within it.
Non-adherence to these instructions may lead to property
damage and serious accidents.
- Examine the system frequently to check for any signs of
damage. Do not use the device if it needs to be repaired.
Warning
All operations which require the casing to be opened (such as
wire connection, programming, etc.) must be carried out during
installation, by skilled staff only. For any other procedure which
requires the casing to be opened again (re-programming, re-
pairs or site modifications), please contact the technical assis-
tance service.
hereby declares that the below products:
BeWeather Series
conform to the specifications in the Directives R&TTE
99/5/EC, EMC 2004/108/EC, LVD 2006/95/EC.
F
OR THE
I
NSTALLER
–
I
MPORTANT
- The BeWeather control unit must be permanently connected
to the power supply network and is not equipped with any
type of 230 V a/c electric line sectioning device. The installer
is responsible for installing a sectioning device in the system.
An omnipolar switch with overheating category III must be in-
stalled. It must be positioned in such a way that it is protected
against accidental closures.
- For connections (power supply and outlet contact) we rec-
ommend the use of flexible wires with an insulating sheath in
harmonised polychloroprene (H05RN-F). The wires should
have a minimum cross-section of 0.75 mm
2
.
- Fasten the connection cables using the cable clamp sup-
plied with the product kit.
- Handle the control unit with care during the installation
process
and make sure that all components are properly assem-
bled. Pay particular attention to the ceramic plate and the
flat connection cable. When closing the box again, it must
fold back on itself normally.
- It is very important to establish an exact location so that the
product is exposed to weather conditions it can control.
- Fix the device to the wall using the screws and rawlplugs
supplied with the product, in the correct position (see figure
below).
- Make sure that the control unit remains tilted at approxi-
mately 45 degrees (Fixing area at the top, round end of the
box at the bottom).
- Do not paint or varnish the sensitive surface of the control
unit.
- The dirt which accumulates on the surface of the rain sen-
sor restricts its sensitivity: we therefore recommend that it is
cleaned once or twice a year using a damp cloth, after the
electricity supply has been disconnected.
- Connect the earth wire of the motor to the earth wire of the
electrical system using the special terminal on the control
unit, as illustrated in the connection diagram.
For the radio receiver to operate correctly when two or
more control units are used, we recommend that you install
the devices at least 3 metres away from each other.
