Motorino XPa, Инструкция по сборке и эксплуатации

Страница: 12 / 25

1 1
BATTERY
BEFORE OPERATING YOUR NEW FOR THE FIRST TIME, CHARGE THE BATTERY
FOR 8-12 HOURS, BUT UNDER NO CIRCUMSTANCES IN EXCESS OF 1 8 HOURS.
Be sure to charge the after each use. Keeping the battery properly charged
will help extend the battery life. Do not use the while the power indicator on
the instrument panel shows low energy. If the is over-used the battery's life
will be reduced. The uses a 48V (volt) battery pack. To charge the battery,
connect the 3-pin plug into the charging receptacle located directly below the front seat.
The battery must be charged while installed in the . If you notice anything
unusual about the battery such as a cracked or leaking battery case, a battery that gets hot
while being used or charged, a battery case that appears "puffy" or
"bloated" etc, or there are any other problems with the battery,
please contact your local Motorino dealer. The battery is sealed
and is NOT user serviceable. Do not attempt to repair, remove,
adjust or in any way alter any internal or electrical components,
controls or wiring without first speaking with a customer service
representative.
The main battery weighs approximately fourty eight (48) pounds.
There is no need to remove it from the unless you are
replacing it. Use caution on removal. To replace the main battery pack,
lift the foot mat and unlock the lock located
on the left side of the (using the
ignition key). Proceed to pull the battery out utilizing the
handle. Disconnect the battery cable.The
is equipped with a 48V battery charger that will interrupt
the
charging process once the battery has received a sufficient
charge. Greeenwit Ltd strongly suggests that the charger not
be used in excess of 18 hours to prevent any
unnecessary
wear on the battery or charger itself. Charging for periods
greater than 18
hours may reduce the overall life expectancy
and efficiency of these items.
1. DO NOT CHARGE OR STORE THE CLOSER THAN 20 FEET
FROM ANY FLAME (E.G. FURNACE, FIREPLACE, WATER HEATER, SPACE HEATER)
2. Be sure to only use 110V AC with the charger. Also make sure the plug is
inserted into a three prong grounded AC outlet.
3. PLUG the POWER INPUT CORD into the charging receptacle located below
the front of the seat. See picture above.
4. Plug the 48V battery charger into a 110V AC power source.
5. The CHARGER INDICATOR LIGHT will illuminate confirming that power is connected to the
charger. If the light does not come on check all connections. If it still does not come on after
checking all connections, fuses and that your AC plug is working, unplug the charger and call
your local dealer.
TO AVOID DAMAGE TO THE BATTERY WHEN CHARGING, USE ONLY THE
CHARGER PROVIDED WITH YOUR .
MOTORINO
TM
MOTORINO
TM
MOTORINO
TM
MOTORINO
TM
MOTORINO
TM
MOTORINO
TM
MOTORINO
TM
MOTORINO
TM
MOTORINO
TM
MOTORINO
TM
MOTORINO
TM
MOTORINO
TM
MOTORINO
TM
MOTORINO
TM
MOTORINO
TM
DO NOT DROP THE BATTERY