© Motor City Wash Works, Inc. 48285 Frank, Wixom Michigan 48393 U.S.A.
Phone: 248.313.0272
▪
Fax: 248. 313.0271
REVISION 1.0 09-24-09
www.motorcitywashworks.com
1
SINGLE WANNER PUMP PREP UNIT INSTALLATION MANUAL
Part # HPPREPSYSTEM004
TABLE OF CONTENTS
Equipment Specifications
Page: 1
Suggested Tools and Installation Materials
Page: 2
Installation Instructions
Page: 3
Start-Up Procedures
Page: 3
Maintenance
Page: 5
Equipment Specifications
Equipment Features
This
Wanner High Pressure Pumping Station
has one pump on a single frame. The pump will
deliver about
9 GPM @ 900 PSI (34.1 LPM @ 6.21 MPa).
This pump is capable of delivering
fresh water as well as filtered reclaim water. Typically used as a prep station, this unit uses one
Wanner D10 Hydra-Cell Pumps
and is belt-driven by a
7 1/2HP electrical motor.
Suggested Installation Tools and Materials
5
Hammer Drill with 3/8” Drill Bit
(8) Wedge Anchor Bolts 3/8” x 4”
Sledge Hammer
Safety Goggles
Set of Standard Combo Wrenches
Torpedo Level
Measuring Tape
Safety Goggles
Notes and safety Symbols
Where necessary, important points will be highlighted in this manual, using the following symbols:
NOTE:
PROVIDES FURTHER INFORMATION!
PREP UNIT
HPPREPSYSTEM004
DIMENSIONS
UNIT LENGTH
45 IN
UNIT WIDTH
34 IN
UNIT HEIGHT
30 IN
UNIT WEIGHT
500 LBS
ELECTRICAL
7 1/2 HP 3-phase 208-230/460 VAC
23.3-21/10.5 AMPS
PNEUMATICS N/A
WATER
9 GPM @ 900 PSI
