6.2 Details of Jig Mounting Face
6-2
HS0481357
HS0481357
6.2
Details of Jig Mounting Face
The jig mounting dimensions are shown in " Fig. 11 Details of Jig Mounting Face ". It is
recommended that the table and the jig be mounted using an inside dowel and dowel pin, or
two dowel pins. The dowel pins are to be prepared by customers.
Fig. 11 Details of Jig Mounting Face
It is recommended that a hole of 300 mm dia. or more be made on the rotational center of the
jig baseplate for maintenance of the positioner's motor. Be sure to mount a cover on the hole
so that spatters and the like will not go inside the MOTOPOS.
Fig. 12 Cover Mounting Example
Wash OFF anti-corrosive paint (solid color) on the jig mounting surface with thinner or light
oil before mounting the tools.
PCD450
19
22.5
°
11.25
°
13.5 dia. hole (8 holes):
equally spaced
12 dia. tapped hole (8 holes):
equally spaced
480 dia.
0
-0.040
360 dia.
Units: mm
10 dia. dowel hole
(4 holes)
+0.018
0
NOTE
300 mm dia. or more
Cover
Baseplate (Jig)
Table (MOTOPOS)
(Hole for maintenance)
