Australian owned
Australian designed
Motolux is a world-class manufacturer of motorisation products and systems dedicated to window covering markets
worldwide. A designer and manufacturer of a fully integrated range of motorisation solutions, Motolux products are
suitable for commercial or residential use. Our high quality product range is streamlined to simplify the process of
manufacturing, installation and ongoing maintenance of almost any type of motorised window covering product.
61 (0)3 9876 0400
[email protected]
www.motolux.com.au
Ordering Information
Australia / New Zealand
Changing from 3 Wire To 4 Wire Mode
Changing from 4 Wire Mode back to 3 Wire Mode
Simple Programming
Changing Motor Direction
PROGRAMMING INSTRUCTIONS 1/3
1.
Connect the following wires to a 3 wire test lead: Brown (Active), Blue (Neutral) and Green/Yellow (Earth). If you are
using a test lead that accommodates both 3 and 4 wire, set it to the RF or RTS setting.
2.
Power up the motor and pair the remote control by following the steps below.
Once the Remote has been paired:
To change from 3 Wire to 4 Wire – Press and
hold
the
UP
and
STOP
Buttons at the same time for approximately 5 seconds,
the light on the bottom of the motor will flash
RED
three times indicating the change from 3 Wire Mode to 4 Wire Mode.
1.
Pairing the motor to the remote:
Start by selecting the Channel that you want to pair the motor with on the remote control.
Next
2.
On the bottom of the
Motor
using a paperclip or a small screwdriver push and
hold
the programming button for
approximately 1 second and the light on the motor will slowly flash
Red
.
3.
Now on the
Remote Control
push the
UP button
. The light will change from flashing
RED
to
3 BLUE
flashes, indicating
that pairing was successful.
1.
Check the Direction: If the direction is correct there is no action required; move to
Limit Setting
.
2.
If the direction is wrong,
push and hold the STOP button for approximately 5 seconds
until the light starts flashing
RED
slowly. Within 10 seconds
push the STOP button
again. The light will change from
flashing RED
to
3 BLUE flashes
,
indicating that the change of direction was successful. Test the curtain and the direction should now be correct.
On the bottom of the motor you will notice a small hole
on the opposite side to the power cord, the programming
button is found inside this hole.
The default setting on these motors is a 3 Wire RF mode. If
the motors are being connected to an Automation System
and being switched by relays, they will need to be changed
to a 4 Wire mode.
Please follow the steps below after pairing a remote control.
The UP button should be used to open the curtain and the DOWN button should be used to close the curtain.
Once the Remote has been paired:
To change from 4 Wire back to 3 Wire – Press and
hold
the
UP
and
STOP
Buttons at the same time for approximately 5 seconds,
the light on the bottom of the motor will flash
BLUE
three times indicating the change from 4 Wire Mode to 3 Wire Mode.
REVISION 2 - 2020
Curtain Motor 1.5Nm 240V AC Hybrid Power - 592130000 (MR68-1.5/100-EM-P)
