Page 6
to delete the digits.
The outside line access code is dialed prior to any number over 6 digits stored in the
directory, memory buttons, or the caller ID memory. A stored number with 6 or fewer
digits is considered an inside number. The outside line access code is not dialed for an
inside call. A PAUSE period or 3 seconds delay is inserted automatically between the
outside access code and the phone number.
8. Press
the
Menu
or
Save
button to save these operating settings and to exit the menu
mode.
9. After installation, lift the telephone's
Handset
and listen for the dial tone. If there is no
dial tone, check to make sure all cords are firmly plugged into their jacks.
Note: Programming your area code will allow you to easily dial numbers that are in your
Caller ID list. See the Section “
Calling Back a Number from the Caller ID List”
for more
information on dialing calls from your Caller ID list.
Wall Mounting
1. Turn the phone over so that you are looking at the bottom of the phone. Insert tabs at
the thin end of the wall mount bracket into the holes at the
rear of the phone bottom. Press and latch the tabs at the
thicker end of the wall bracket into holes at the front end of
phone. The back of the phone should then have two round
plastic holes that can be used to hang your phone on the wall.
2. Use the two round holes to hang the phone on the wall plate on your wall.
Important Note
: If you do not wish to mount your phone on the wall, the
Wall Mount
Bracket
can be reversed to raise the angle of the phone's display when sitting on a table
or desk.