www.motionrc.com
Motion RC User Guide for the Detrum RXC6 Receiver
Page 5
11.
Press and hold the Bind button down until the Bind light flashes more slowly; when the
light slows down, release the Bind button. The receiver is in Bind mode.
12.
Hold the switch you identified in step 8 in the bind position (such as the TRAINER
switch on GAVIN-6C, which you hold toward the front of the transmitter) and turn the
transmitter on. You hear the bind tone on the transmitter and the Bind light on the
receiver becomes solid, indicating the bind process is complete.
13.
Move the control associated with the servo you connected to ensure it moves. If so, the
model is bound. If not, repeat this process until it is successful.
14.
Power off the receiver.
15.
Power off the transmitter. You are ready to install and program the receiver.
Mount the Receiver in a Model and Secure its Antennas (If
Required)
1.
Connect the servo and ESC leads to the corresponding ports on the receiver.
2.
Position the receiver in the model trying to avoid the antennas being blocked by the
battery, ESC, or other components. As you decide where to place the receiver in the
model, you should also ensure the antennas remain pointing 90 degrees to each other so
they have the most reliable reception possible.
3.
Use double-sided tape or hot glue to mount the receiver in the model.
4.
If the antennas run along a surface, such as the side of the fuselage, secure the antennas in
position with tape. If the antennas are hanging in space, they will probably be fine. The
key point is to ensure they remain at a 90-degree angle to each other and aren’t covered
by batteries or other components that could distort or disrupt signals from the transmitter.
