- 6 -
2.1
2.1
Cane Clamp Installa
Cane Clamp Installa
tion
tion
1. Loosely install the cantilever armrest onto each back cane (left and right) via the cane clamp assembly- see
Figure 1.0
below.
2. Working on one back cane at a time, determine the desired height of the cantilever armrest and secure the
cane clamp assembly onto the back cane using the hardware provided.
(
Note:
fine tune height adjustments
may be required to complete the installation of the crossbar assembly- see Section 2.2)
Note
:
the height of the left and right cantilever armrest assemblies may be
offset
offset from each other by up
to
1.5”
(if desired); please refer to
Figure 2.0 - Crossbar Installation
for instructions.
Important!
The following section provides installation and adjustment instructions for the Tilt-Only Cantilever
Armrest Assembly. If the Cantilever Armrest has already been installed on the seating system,
please proceed to
Section 2.4
Section 2.4 for instructions on adjusting the armrest angle.
Note:
The following instructions/images show the installation of the cantilever armrest onto the
right side of the seating system, repeat all steps indicated to complete the left armrest installation.
cane clamp
starting on either side of the wheelchair
determine the desired height* for the
cantilever armrest, and secure the cane
clamp assembly onto the back cane
*note:
the left and right armrest assemblies may
be offset from each other by up to 1.5” (if desired)
Cantilever Armrest
Tube
T
ilt Back Cane
Figure 1.0
mounting
plate
right cantilever assembly shown
2
2..0
0 IIn
ns
stta
alllla
attiio
on
n &
& A
Ad
djju
us
sttm
me
en
ntt
Содержание TRD0274
Страница 2: ......