Motic SWIFTLINE SM100 Series, Инструкция по эксплуатации

Страница: 8 / 13

8
BULB REPLACEMENT
Unplug the stereo microscope from the electrical outlet and
remove specimens from the stage before you attempt to replace
an LED.
To prolong the life of the LED, you should always turn off the unit
when not in use.
The extra long life LED incidental (top) illuminator bulbs (Swift
MA14780 & MA14781) can be replaced by removing the five retaining
screws holding on the Illumination plate (See Fig 1.). This will
require the use of a short handle screw driver. They can then be
unclipped and replaced (See Fig 2.).
The transmitted (bottom) illumination bulb is Swift MA14782 3.5V
150mA LED Bulb. The bottom bulb may be replaced by carefully
laying your stereoscope on its side and using a Phillips screw driver
remove the four screws securing the rubber feet and base plate to
illuminator base. Remove four 3mm Phillips head screws securing
lamp housing to lamp bracket (See Fig 3.); then remove lamp
housing. Carefully unplug LED lamp connector. Replace LED lamp
assembly and then, reverse the above process.
*Picture in Fig 1 is SM105 series – SM101 and SM102 series do not
have covers*
Fig 1. Fig 2.
Fig 3.