14
15
Mother’s Choice |
Flair II
Mother’s Choice |
Flair II
Front of vehicle
Vehicle metal
structure
Spacer(s)
(if required)
Attachment bolt
Anchor fitting
Vehicle trim
1
Centre line of
seating position
200mm
min.
FOR SEDANS ONLY:
2
Vehicle metal
structure
Spacer(s)
(if required)
Attachment bolt
Anchor fitting
Vehicle trim
Lock washer
Nut
Reinforcing
washer
3
PREPARING SEAT AND VEHICLE
For cars fitted with a child restraint upper
anchorage point:
Locate the upper anchorage point behind the rear
seating position (consult the car owner’s handbook
for the location of the upper anchorage point).
Remove the thread plug from the parcel shelf/floor/
roof and install the attachment bolt as shown in
Figure 1.
CAUTION: DO NOT OVERTIGHTEN THE
ATTACHMENT BOLT. OVERTIGHTENING MAY
FRACTURE OR BREAK BOLT. MAXIMUM TORQUE
IS 20 Nm.
For cars not fitted with a child restraint upper
anchorage point:
For sedans only:
Drill a 9mm diameter hole in the parcel shelf on the
centre-line of the seating position as shown in Figure
2. Install the anchor bolt as shown in Figure 3. It is
recommended that this installation be carried out
by a child restraint fitting station or licenced motor
mechanic.
For vehicles other than sedans:
In Australia, consult your nearest child restraint
fitting station or traffic authority for vehicle
inspection to find the best, correct position for the
placement of the upper anchorage point, and for the
correct attachment bolt length and use of spacers.
In New Zealand, consult the agent for the vehicle.
