Motak PKM0335, Инструкция по установке и эксплуатации

Страница: 29 / 137

Part Number: 000016426 Rev 00 08/2020 29
Section 2 Ice Machine Operation
WATER LEVEL CHECK - PKU0155 ONLY
Before water will flow into the water trough, the float valve shut-off must be in the OPEN
position. The float valve is factory-set for the proper water level. If adjustments are
necessary:
1. Verify the ice machine is level.
2. Remove the siphon cap from the standpipe.
3. Place the main ON/OFF/WASH toggle switch to the ON position, and wait until the
float valve stops adding water.
4. Adjust the water level to (1/4" to 3/8" [6.3 to 9.5 mm] below the standpipe) the line
in the water trough:
A. Loosen the two screws on the float valve bracket.
B. Raise or lower the float valve assembly as necessary, then tighten the screws.
5. Move the main ON/OFF/WASH toggle switch to the OFF position. The water level in
the trough will rise above the standpipe and run down the drain.
6. Replace the siphon cap on the standpipe, and verify water level and siphon action by
repeating steps 3 through 5.
ICE THICKNESS CHECK - PKU0155
After a harvest cycle, inspect the ice cubes in the ice storage bin. The ice thickness probe is
set to maintain an ice bridge of 1/8" (3.2 mm). If an adjustment is needed, follow the steps
below.
1. Turn the ice thickness probe adjustment screw clockwise for a thicker ice bridge, or
counterclockwise for a thinner ice bridge.
2. Make sure the ice thickness probe wire and bracket does not restrict movement of
the probe.
ADJUSTING
SCREW
Ice Thickness Adjustment