Morso SQUIRREL 551, Руководство пользователя, Страница: 9 / 12

8 9 8
FITTING THE CERAMIC FUEL EFFECT
AND
BURNER COMPARTMENT WALLS
Ceramic fuel effect and Burner compartment Walls
• This product uses fuel effect pieces and burner compartment rear wall
containing Refractory Ceramic Fibres (RCF), which are man­made vitreous
silicate fibres. Excessive exposure to this material may cause irritation to
eyes, skin and respiratory tract. Consequently, it is important to take care
when handling these articles to ensure that the release of dust is kept to a
minimum.
• Light coatings of soot will usually be burnt off during the normal operation
of the fire.
• Should any soot accumulation become excessive, the fuel effect pieces
and walls should be removed from the fire for cleaning.
• Cleaning should be carried out in a well ventilated area or in the open air by
gently brushing with the pieces held away from your face so that you avoid
inhaling the dust.
• We suggest that you remove the coals in the reverse order to that shown
in this section of the guide. When removing the fuel effect and burner com­
partment walls it is important that the front grate is removed before the fuel
effect pieces. To do this hold the front grate firmly and lift.
. Place the rear ceramic wall against the back of the firebox.
. The rear ceramic wall must be located onto the ledges at the back of the
rear base ceramic (See figure 5). To achieve this, hold the rear ceramic wall
against the rear of the firebox at its uppermost position. Whilst holding the
rear ceramic wall in this position locate the rear ceramic base coal into
position (See figure 5). The rear wall can now be released. Ensure that the
rear ceramic wall sits on the ledge at the back of the rear base coal.
Figure 5