Morso 3600 Series, Инструкция по установке и эксплуатации

Страница: 16 / 24

16
DK ENG
1. When you open the door, you will find two small M4 unbraco screws, one in each hinge.
Unscrew the two screws, lift the door off the hinges and place it face down on a sheet of
cardboard or other nonabrasive fabric.
2. Unscrew the 4 bolts that secure the glass. (In the event that a bolt sheers off when being
unscrewed, remove the remaining body of the bolt by drilling down its cnetre with 1/8
inch high speed steel drill bit. Smaller drill bits may be successful, but do not use a lager
bit. Make sure the bit stays away from the edges of the bolt - this may damage the thread
in the cast iron).
3. Remove the old ceramic gaskets and clean up the surface underneath with wire wool or
emery paper to remove loose particles.
4. Place the new gasket material in position around the perimeter of the window area, mak-
ing sure to pinch them to the length in such a way that they make a continuous seal. Leave
no gaps.
5. Place the new glass in position on the strips and screw home the fresh bolts and fitting
by hand.
6. Finally, give each of the bolts an extra half turn or so. The glass should held tight enough
by that cleaning will not dislodge it. Do not over-tighten the bolts as this may put exces-
sive pressure on the glass, resulting in cracking - important!
To reduce the risk of breaking the glass, avoid striking the glass or slamming the door.
Internal service parts
The flame-path equipment - consisting of the ashpan, grate, firebricks, Cast iron fire plates,
glass, baffle and flue collar - are subject to the extremes of heat produced by the fire. From
time to time, one or other of these parts may need replacing as a matter of routine main-
tenance.
NOTE: The flame-path equipment, the ceramic rope and the paint finish are not covered
by guarantee.
All of these service parts can be bought from your Morsø dealer, and we recommend that
damaged parts are replaced as soon as possible to avoid collateral damage.
Should the baffle be distorted by an overfire, the stove will still function, although its efficien-
cy may be compromised. Replace it as soon as possible. The radiation shield on the back of
the stove is first removed by loosening the 4 screws. The rear casing is removed (four bolts).
Remove these and remove the 2 M8 bolts keeping the baffle plate. withdraw the baffle from
the firebox.
Before replacing the baffle, scrape out the old fire furnace and replace with new to make
an effective seal.
Reasons for fast internal wear and tear
Persistent heavy firing
Soot and ashes left to accumulate