5. Pull the grip pad clamp handle to close the grip
pads tightly on the drum. Ensure that the chime
catches on the two parallel drum-supporting
bars are immediately under the top rim of the
drum
6. Raise the “LIFT” control handle. The grip pads
and chime catches will lift the drum. Continue
to raise only until the drum is 6”-12” clear of the
floor, or when the arrow indicator is within the
yellow bar. This height must be sufficient to
permit the drum to swing clear of the floor when
tilting to horizontal. Visually inspect the drum
holder assembly and position of the drum to
verify proper engagement of the grip pads and
chime catches.
WARNING
- Stay Clear of Raised Drum
NEVER allow anyone to be below any part of a raised drum handler or drum. Remain
behind the push handle while handling a drum.
WARNING
– Do NOT Disengage the Grip Pad Clamp Handle When Vertical Drum
is off the Ground
When the drum is in the vertical position, lower the drum to the floor before
releasing the grip pad clamp handle.
7. After ensuring that the area in front of the MORStak is clear, tilt the drum to the horizontal position by pushing
down on the “TILT” control valve. Do not raise the drum until you have reached the racking area. It can be
unsafe to move the MORStak with a raised drum.
MORStak Drum Rackers
611 Series: Single–Stage Mast, racks to 58”
620 Series: Two-Stage Mast, racks to 102”
The Specialist In Drum Handling Equipment
Website:
www.MORSEmfgco.com
COPYRIGHT 2002-2004 MORSE MFG. CO., INC.
Form PL 600
(181180-211427)
(Updated 4/2004)
Page 6
