The Specialist In Drum Handling Equipment
Operator’s Manual for Morse Power Grip Fork Mount Drum Handler Model 290F
Serial Number 291995 to ______
morsedrum.com
Copyright 2020 - Morse Mfg. Co., Inc.
Form PL290F (291995-______)
(Updated 26 Oct, 2020)
4
Model 290F
Power Grip Fork Mount Drum Handler
Maintenance
Using grease fittings to lube each end of the cylinder clevises in drum grab assembly. Recommended frequency: Every 6 months.
1.
Clean and oil moving parts periodically. Clean & lubricate more often in environments where dust, dirt or other foreign particles will
2.
effect the performance of moving parts.
Periodic inspection for the general condition of structural and mechanical components is imperative for safe and efficient operation.
3.
Periodically inspect all moving parts, framework, and contact areas for signs of wear, fatigue, or loosening. Tighten, adjust, or replace
4.
parts as necessary to prevent failure and maintain proper function.
Inspect the hydraulic system for oil drips, hose damage, or other signs of wear. Inspect the level and condition of the hydraulic fluid.
5.
Replace any parts that show signs of wear.
Worn or damaged parts must be properly replaced with the correct, genuine Morse parts.
6.
Hydraulic pump is shipped filled with Noco Premium plus automatic transmission fluid d/m. Material safety data sheet (msds)
7.
is available online. Change oil yearly, or sooner depending on dirty conditions or outdoor use. Replace oil with Mobil dte 24 or
equivalent for indoor use (Mobil dte 13 for outdoor use).
Using Proper Grip Pressure:
4.
Press the GRIP “CLOSE” button to close the grippers around
the drum, ensuring there is adequate pressure to handle the
drum but not crush it.
Grip Pressure Adjustment:
With 11/16” wrench loosen lock nut. Then use 3/16” hex
wrench to adjust the pressure control valve. Clockwise will
increase the hydraulic pressure.
Raise forks to clear the floor and transport drum in vertical
5.
position to dispensing location.
To pour drum: Press the TILT “FWD” button on the pendant,
6.
rotating drum to angle required for dispensing.
When dispensing is completed, rotate the drum back to
7.
vertical by pressing the TILT “REV” button on the pendant.
While transporting, ensure that the drum is raised away from
the floor to prevent the drum bottom from interfering with a
pallet or other obstacle.
Lower drum to rest on floor, pallet, or other suitable surface.
8.
To release drum grip, hold down the red SAFETY button, and
9.
press the GRIP “OPEN” button. The grippers will NOT open by
pressing only the GRIP “OPEN” button.
Operating Instructions (continued)
