MACHINE PREPARATION and OPERATION
(Cont.)
BEVEL CUTTING ADJUSTMENTS
1 Release both locking handle and wingnut. (fig. 18
A
/ 18
B
)
2 Adjust to the required cutting angle by lining up the mark
with the printed scale in the bevel support.
3 Tighten both handle and wingnut to lock into position.
PARALLEL BLADE GUIDE
To set the guide:
1 Loosen the two retaining screws. (fig. 19
A
/ 19
B
)
2 Slide the guide up snugly against the side of the work
piece.
3 Using a measuring tape, check that the distances from
the front and the back of the blade to the edge of the
blade guide are equal. This will ensure that the guide
is parallel to the blade. The guide should be parallel
to the blade, and not to the base of the tool, to avoid
damage to both blade and motor.
4 Retighten the screws.
CHIP COLLECTION AND REMOVAL CHAMBER
Removal:
1 Loosen the knob bolt holding the collection unit to the
saw
(fig. 20)
a.
The chips accumulating can be seen in the collection
chamber window.
b.
Chips should always be emptied when chamber is
approximately half full.
2 Tilt saw so collection unit is face down.
3 Pull collection unit away from saw (fig. 21)
4 Gently shake chips out of chamber into proper disposal
bin.
Note:
The knob bolt remains fastened to the collection chamber.
Re-Attaching:
1 Place the saw upright
2 Place place hook into inset on the front of saw. (fig. 22)
3 Place collection unit onto side of saw in order for the
knob bolt to be tightened.
7
(fig. 18
B
)
(fig. 20)
(fig. 18
A
)
For certain compound cuts it
may be necessary to manually
retract the guard to allow the
blade to enter into and / or through the cut.
Be extremely careful when
making these cuts,as the guard will not protect you from injury.
Metal chips may be very hot and sharp.
Wear eye protection whenever you open
the collection chamber.
Never touch metal refuse with bare
hands.
READ AND SAVE ALL INSTRUCTIONS FOR FUTURE USE!
(fig. 21)
(fig. 22)
(fig. 19
A
)
(fig. 19
B
)
Содержание CSM9NXTB Metal Devil
Страница 31: ...CSM9NXTB ...
