The Specialist In Drum Handling Equipment
MODEL 82H
Mobile Lifter / Palletizer
Operator’s Manual for Model 82H Morse Mobile Lifter / Palletizer
Serial Number 0509 to 1110 (MMYY)
MorseDrum.com
Copyright 2011 - Morse Mfg. Co., Inc.
Form PL82H (0509-1110) (Updated January 27, 2011 2:07 PM)
4
Operating Instructions
Roll drum lifter to drum. Steer unit so head and bottom support meet
1.
centerline of drum. Head should push into side of drum near drum top.
Exact height is not critical. Jaws should arrive below drum rim. This
usually corresponds to having top of head about as high as top of drum.
WARNING:
Keep hands and other objects away from top opening of
lifting frame.
To clamp drum: Operate lift function to raise head while it is held against
2.
the drum. Drum-gripping action is automatic as the head rises. This is
how it works: As the head rises, the lower jaw will come up under the lip
of the drum rim, “catch” under it, and be held down. As the head rises with
the lower jaw thus held by the drum rim, internal linkage will pull the upper
jaw downward to meet the top of the drum rim. The drum’s weight on the
lower jaw creates the force that pulls the upper jaw down to tightly grip the
drum rim. No manual contact is required.
WARNING:
Keep hands and other objects away from drum-gripping
jaws.
With drum held off the floor, push drum lifter to deliver drum. Avoid
3.
unreasonably rough or non-level surfaces. Move at moderate speed.
Carry drum only high enough to avoid contact with the floor or obstacles.
Push loaded unit when possible for transporting. Pulling unit should be
limited to maneuvering at short distance.
WARNING:
Excessive pitching or bouncing caused by rushing over
rough or non-level floors can make drum momentarily weightless,
jaws can disengage.
To release drum at intended destination: operate control to lower drum
4.
onto level floor or pallet. When drum comes to rest and head continues
to lower, weight will no longer be on the lower jaw and jaws will open
automatically. No manual contact is required. Do not stop lowering as
soon as drum touches down, keep going down for a few more inches. Pull
unit away once upper jaw has retracted clear of drum rim. Park unit on
level floor, out of traffic lanes when not in use.
Adjustment for Shorter Drums: The head is factory set in upper position
5.
for handling drums at least 34” tall, including typical 55 gallon drums. For
handling drums as short as 28” such as typical 30 gallon drums, relocate
head downward as follows: Detach head by removing nuts that hold head
to lifting assembly. Reattach head at alternate location 6” lower.
Maintenance
Periodic inspection for the general condition of structural and mechanical components is imperative for safe and efficient operation.
•
Periodically inspect all moving parts, framework, and contact areas for signs of wear, fatigue, or loosening. Tighten, adjust, or
•
replace parts as necessary to prevent failure and maintain proper function.
Inspect the hydraulic system for oil drips, hose damage, or other signs of wear. Inspect the level and condition of the hydraulic fluid.
•
Replace any parts that show signs of wear.
Grease wheel bearings periodically. Clean and lubricate all moving parts including: Cylinder pin and linkages.
•
Worn or damaged parts must be properly replaced with the correct, genuine Morse parts.
•
Hydraulic pump is shipped filled with Noco Premium plus automatic transmission fluid d/m. Material safety data sheet (msds) is
•
available online. Change oil yearly, sooner depending on dirty conditions or outdoor use. Replace oil with Mobil dte 24 or equivalent
for indoor use (Mobil dte 13 for outdoor use).