The Specialist In Drum Handling Equipment
Model 82AM-GT
Mobile-Karrier / Palletizer with Geared Tilt
and Spark Resistant Parts
operator’s Manual for Model 82AM-GT Morse Mobile-Karrier / Palletizer
Serial number 0315 to ____ (MMYY)
morsedrum.com
Copyright 2019 - Morse Mfg. Co., Inc.
Form OM82AM-GT (0315-____) (Updated 12 Jun, 2019 9:35 AM)
4
operating Instructions
Roll drum lifter to drum. Steer unit so drum holder meets middle
1.
of drum. Operate hydraulics as necessary. Roll the unit forward
and push drum holder so it slips around the drum.
WARnInG:
Keep hands and other objects away from top
opening of lifting frame.
To secure drum: drape cinch chain across face of drum and
2.
engage a link into notch in hub of ratchet. Pull up on ratchet
handle to tighten chain. If ratchet turns to extent that pawl is
beyond last ratchet tooth and chain is not tight, back up and try
putting next link in notch. Chain should tighten as ratchet turns
and be held tight by teeth of ratchet & pawl. Firm hand pressure
on ratchet handle should tension chain sufficiently to secure
drum. DO NOT use mechanical aids such as a pipe to extend
ratchet handle for extra leverage.
Operate lift function to raise drum off the floor, push drum
3.
lifter to deliver drum. Avoid unreasonably rough or non-level
surfaces. Move at moderate speed. Carry drum only high
enough to avoid contact with the floor or obstacles. Push
loaded unit when possible for transporting. Pulling unit should
be limited to maneuvering at short distance.
Lift drum to desired pouring height. Operate the tilt control as
4.
described in “Machine Description - Controls” (page 3) to adjust
the drum attitude. When dispensing is complete, tilt drum back
to upright position. Lower drum to transporting height.
Before unloading drum, return drum to upright. Lower drum at a
5.
controlled rate.
To remove drum: pull ratchet handle clockwise to relieve
6.
pressure on ratchet teeth. Lift pawl handle to release teeth
engagement and rotate ratchet counterclockwise to loosen
chain and allow its removal from notch. Pull unit away and park
on level floor, out of traffic lanes when not in use.
Adjustment for Shorter Drums: The drum holder assembly is factory set in upper position for handling typical 55 gallon (208 liter)
7.
drums. For handling shorter drums such as typical 30 gallon (114 liter) drums, relocate drum holder assembly downward as follows:
Detach by removing nuts that hold it to lifting assembly. Reattach at alternate location 6” lower.
Maintenance
Periodic inspection for the general condition of structural and mechanical components is imperative for safe and efficient operation.
•
Periodically inspect all moving parts, framework, and contact areas for signs of wear, fatigue, or loosening. Tighten, adjust, or
•
replace parts as necessary to prevent failure and maintain proper function.
Inspect the hydraulic system for oil drips, hose damage, or other signs of wear. Inspect the level and condition of the hydraulic fluid.
•
Replace any parts that show signs of wear.
Grease wheel bearings periodically. Oil or grease all moving parts including: Tilt gears, sprockets, chain, the hinge pin, and the
•
ratchet and pawl.
Worn or damaged parts must be properly replaced with the correct, genuine Morse parts.
•
Hydraulic pump is shipped filled with Noco Premium plus automatic transmission fluid d/m. Material safety data sheet (msds) is
•
available online. Change oil yearly, sooner depending on dirty conditions or outdoor use. Replace oil with Mobil dte 24 or equivalent
for indoor use (Mobil dte 13 for outdoor use).
