The Specialist In Drum Handling Equipment
Model 400A-96SS-124
Stainless Steel Hydra-Lift, 96”,
Air Power Lift, Manual Tilt
Operator’s Manual for Morse Stainless Steel Hydra-Lift Karrier Model 400A-96SS-124
Serial Number 0213 to ____ (MMYY)
morsedrum.com
Copyright 2022 - Morse Mfg. Co., Inc.
Form OM400A-96SS-124 (0213-____)
(Updated 3 Mar., 2022)
4
Figure 3.1
WARNING
- Watch Out for Pinch Points
Stay clear of moving parts. Operator should
remain behind the push handle during the lift
operation.
Floor Lock
The step-down floor lock is located behind the base (figure
3.1). To activate, step down on the floor lock until it locks
in down position. When floor lock is activated it prevents
unwanted free wheeling of unit. Floor conditions determine
effectiveness of floor lock. Operator should verify its holding
action before depending on it to hold.
Drum Holder Assembly
The MORCINCH
TM
Drum Holder (Saddle) assembly is the
component on intended to hold the drum. It is designed to secure
a standard ribbed 55-gallon (210 liter) steel drum around it’s middle
using a cinch chain and ratchet tightening system. It automatically
adjusts for 22” to 23.5” (56 to 59.7 cm) diameter drum.
The MORCINCH
TM
Drum Holder also accepts accessories to
handle a plastic drum, fiber drum, or a smaller diameter drum.
Figure 2.3
Controls
The Morse Hydra-Lift Karrier is manually propelled and steered. The drum lift
is powered by an air motor with an on/off valve. There are two functions for the
operator to control (Figure 2.3):
1.
LIFT and Lower Function to raise and lower the drum
•
Plug your air line into the on/off air valve.
•
Turn the motor on by holding the valve handle in the on position. The
drum will lift.
•
Release the valve handle when the drum is at the desired height.
•
To lower the drum: With the motor off, push in the LOWER handle.
2. TILT Function to control the degree of rotation of the drum.
•
Turn the hand crank to turn the drum.
•
Before releasing your grip on the hand crank, pull out the crank stop
pin to block the hand crank from spinning freely.
•
If the drum handler is equipped with the MORStop Tilt-Brake, there is
no need to use the stop pin. Braking is immediate and self-actuating,
without additional steps by the operator.
Note: To add the MORStop Tilt-Brake to an existing drum handler, order
part # 3900SS-P for a field installation kit.
