The Specialist In Drum Handling Equipment
Model 310-1-50-CE & 310-3-50-CE
CE Marked Tilt-To-Load Drum Rotators
operator’s Manual for Morse 310-CE series CE Marked Tilt-To-Load Drum Rotators
serial number 278575 and up
morsedrum.com
Copyright 2019 - Morse Mfg. Co., Inc.
Form PL310-CE (278575-309424)
(Updated 16 Oct, 2020)
6
Base Assembly
(not sold separately)
Tilt Assembly
(not sold separately)
Drum Holder (saddle) Assembly
Part # 5801-P
Mast Assembly
Part # 5762-P
with Controls
Unloading a Drum
Ensure the drum is in vertical upright position to unload.
1.
Squeeze the ratchet release lever and open all the way to unlock, then release the tension on the strap. Allow enough slack in the
2.
strap in order to remove strap loop from clevis.
Loosen top clamps and swing clear of drum.
3.
Remove drum with appropriate drum handling equipment.
4.
Maintenance
Periodic inspection for the general condition of structural and mechanical components is imperative for safe and efficient operation.
Inspect the hydraulic system for oil drips, hose damage, or other signs of wear. Inspect the level and condition of the hydraulic fluid.
1.
Hydraulic fluid level should be within a ½” of the top of the reservoir when the cylinder is in the relaxed position. Replace any parts that
show signs of wear.
Lubricate all moving parts including: bearings, clevis pins, and threaded rod.
2.
Periodically inspect all moving parts, framework, ratchet, straps, fasteners and contact areas for signs of wear, fatigue, or loosening.
3.
The web strap should be removed from service & replaced if any of the following are visible:
•
Acid or caustic burns
•
Melting or charring of any part of the strap
•
Holes, tears, cuts, snags or embedded articles
•
Broken or worn stitching in load bearing splices
•
Excessive abrasive wear
