The Specialist In Drum Handling Equipment
Model 285A-BP
Battery-Powered Forklift-Karrier
Operator’s Manual for Morse Battery-Powered Forklift-Karrier Model 285A-BP
Serial Number 0413 to 0617 (MMYY)
morsedrum.com
Copyright 2018 - Morse Mfg. Co., Inc.
Form PL285A-BP (0413-0617)
(Updated 2 Oct, 2018 1:37 PM)
4
Operating Instructions
Before sliding forklift forks into the fork tubes, adjust forks to
1.
an inside spread of 25” minimum. Lock forks into position on
the forklift carriage.
Drive the forklift forward to slip the forks into the fork tubes.
2.
Tighten tee screws (item #4) to secure the Forklift Karrier to
the forks.
Release the cinch chain (item #112) and hang the loose end
3.
from the upright peg on the front of the guard. Allow the
ratchet hinge plate to swing to the open position.
Drive the forklift with the Forklift Karrier near floor level to
4.
position the saddle band around the middle of the drum
between the ribs.
Drape the cinch chain across the front of the drum and
5.
insert one link into the slot on the ratchet handle. Turn the
ratchet handle clockwise to tighten the cinch chain around
the drum (shown right).
Remove pendant assembly (item #27) from holder on guard
6.
and place near operator’s seat.
Raise forks to clear the floor and transport drum in vertical
7.
position to dispensing location.
To pour drum: press the down button on the pendant,
8.
rotating drum to angle required for dispensing.
When dispensing is completed, rotate the drum back to
9.
vertical by pressing the up button on the pendant and
return drum. While transporting, ensure that the drum is
raised away from the floor to prevent the drum bottom from
interfering with a pallet or other obstacle.
CAUTION:
DO NOT exceed weight capacity of 1500 Lb. for FULL drum,
800 Lb. for HALF-FULL drum.
CAUTION:
DO NOT allow drum to impact on floor, ground, or dumping station, etc.
Maintenance
Lubricate cylinder pins (items 14 & 11) and linkages (items 8 & 9).
1.
Clean and oil ratchet, pawl, saddle hinge, and other moving parts periodically. (Clean & lubricate more often in environments where
2.
dust, dirt or other foreign particles will effect the performance of moving parts.)
Periodic inspection for the general condition of structural and mechanical components is imperative for safe and efficient operation.
3.
Periodically inspect all moving parts, framework, and contact areas for signs of wear, fatigue, or loosening. Tighten, adjust, or
4.
replace parts as necessary to prevent failure and maintain proper function.
Inspect the hydraulic system for oil drips, hose damage, or other signs of wear. Inspect the level and condition of the hydraulic fluid.
5.
Replace any parts that show signs of wear.
Worn or damaged parts must be properly replaced with the correct, genuine Morse parts.
6.
Hydraulic pump is shipped filled with Noco Premium plus automatic transmission fluid d/m. Material safety data sheet (msds) is
7.
available online. Change oil yearly, sooner depending on dirty conditions or outdoor use. Replace oil with Mobil dte 24 or equivalent
for indoor use (Mobil dte 13 for outdoor use).
* For each size fiber drum, this model requires a 55/30 series Diameter Adaptor.