Morrison BL260E S2 Скачать руководство пользователя страница 8

8

9

What to Check

Possible Cause

Remedy 

Is the engine overheating?

Operator is overworking the machine.

Use lower throttle setting.

Carburettor mixture is too lean.

Return blower to dealer.

Improper fuel ratio.

Re-fill with fresh fuel of the correct 

mixture (2-cycle engine oil and 

gasoline)

Fan cover, cylinder fins dirty or damaged.

Clean, repair or replace as necessary.

Carbon deposits on piston or in the muffler.

Decarbonize.

Engine is rough at all speeds. 

Clogged air cleaner element.

Service the air cleaner.

May also have black smoke and/or

Loose or damaged spark plug.

Tighten or replace.

unburned fuel at the exhaust.

Air leakage or clogged fuel line.

Repair or replace filter and/or fuel line.

Water in the fuel.

Drain the fuel dealer replace the fuel.

Piston seizure.

Return blower to dealer.

Faulty carburettor and/or diaphragm.

Return blower to dealer.

Engine is knocking.

Overheating condition.

Idle engine until cool; find reason for 

overheat.

Improper fuel.

Check fuel octane rating; check for 

presence of alcohol in the fuel. Refuel 

as necessary.

Carbon deposits in the combustion

chamber.

Decarbonize.

What to Check

Possible Cause

Remedy

Does the engine crank?

NO 

Faulty recoil starter. 

YES 

Fluid in the crankcase.

Return blower to dealer

Internal damage.

Good compression?

NO 

Loose spark plug. Excess wear 

Tighten and re-test. Return blower to

YES 

on cylinder, piston, rings.

dealer.

Does the tank contain fresh 

NO 

Fuel/mixture incorrect, stale, contaminated.

fuel of the proper grade?

Re-fill with fresh fuel (2-cycle engine 

oil and gasoline)

YES 

Is fuel visible and moving in 

NO 

Check for clogged fuel filter and/or vent.

Clear as required. Re-start.

the return line when priming?

YES 

Check the spark plug

If the plug is wet, excess fuel may be

Crank the engine with plug removed,

in the cylinder.

replace the plug and restart.

The plug may be fouled or

Clean and regap the plug to

improperly gapped.

0.6-0.7mm. Restart.

The plug may be damaged internally

Replace the plug with a 

or of the wrong size.

Champion RCJ6Y. Restart

Engine does not start

Low Power Output

552528 Morrison BL Vac OM   17/5/06  11:26 AM  Page 9

Содержание BL260E S2













Отзывы: