8
This function is ideal for cleaning underneath low
furniture.
1.
Separate the Lift Away canister
(32)
from the
motorised floor brush nozzle
(23)
by pressing the
Lift Away canister release button
(19)
on the side
of the Lift Away canister.
2.
Press the extension tube release button
(9)
and
pull the extension tube
(8)
up.
3.
Attach the end of the extension tube
(8)
to the
motorised floor brush nozzle
(23)
or Dust Away
Floor attachment
(30)
.
4.
Press the On/Off 3-position switch
(11)
to the “I”
position to turn the suction motor on.
NOTE: The rotating brush bar
(25)
will not rotate
in Lift Away canister mode.
5.
Gently press the motorised floor brush nozzle
(23)
down with your foot while you grasp the handle
(1)
and tilt it back towards you. Tip the unit
backwards to access under low furniture.
When using the attachments, the suction may be
too powerful. Adjust the suction power by rotating
the suction adjustment collar
(3)
90°
anti-clockwise to open the valve to reduce
suction. Less suction may be required for
cleaning delicate areas and upholstery.
Rotate the collar clockwise to close the valve
when you need high suction and for vacuuming
floors.
If the cleaner overheats, a motor protection
thermostat will automatically switch the motor off.
If this happens,
switch the cleaner off, unplug
from the power supply and leave the cleaner to
cool for at least 90 minutes
. Check the airways
for blockages, empty the dust canister and clean
the filters before restarting.
If the rotating brush bar
(25)
becomes jammed, a
safety cut-out will stop the brush and the
motorised floor brush indicator light
(24)
will
change from green to red. If this happens,
switch
off and unplug the product
. Disconnect the
motorised floor brush nozzle and carefully remove
the blockage.
WARNING: Always unplug the vacuum cleaner
from the mains supply before undertaking any
of the following maintenance procedures.
Empty the dust canister
(13)
regularly even if it
does not look full, this will maintain the
performance.
1.
Unplug the cleaner from the mains switch.
2.
Undo the dust canister release latches
(16)
on
each side of the Lift Away canister
(32)
by lifting
them up and outwards.
3.
Remove the dust canister from the motor base
(18)
.
Maintenance
Safety cut-outs
Emptying the dust canister
Cleaning under furniture in
Lift Away canister mode
Adjusting suction power
Certain
models
only
Suction
Release
Collar
VC73410MUK Rev4_Instruction Book 31/10/2012 11:18 Page 8
