the canister lid. The filters can be washed
in warm water then left to air-dry
naturally. IMPORTANT: Ensure the filters
are totally dry before re-fitting. Do not use
detergents.
Central filter
H
4
Lift the central canister filter
out of the
canister.
5
Remove any attached dirt by using the
brush.
6
Re-assemble by replacing the central
canister filter into the canister.
7
Replace the foam filter then the pleated
circular filter into the top of the canister.
Replacing the canister lid
I
8
Replace the canister lid by lining up the
arrows on the canister base and lid and
twisting clockwise to lock into place
I
.
The canister may be washed in water
only but must be totally dry before re-fitting.
The canister has a safety inter-lock that
prevents it from being fitted back into place
if the filters have not been fitted correctly.
Motor protection filter
J
The motor protection filter is located
underneath the dust canister
1
Remove the dust canister.
2
Lift out the filter and shake rigorously
over a dustbin.
The filter may also be washed in water
(no detergents) but must be totally dry before
re-fitting.
3
Replace the filter
Exhaust filter
J
The exhaust filter is located below the
dust canister compartment.
1
Remove the front cover.
2
Remove the exhaust filter by pulling
forward at the top and lift it away.
3
Take the filter out of the cage and shake
vigorously over a dustbin. The filter may
also be washed in warm water. Do not
use detergents. The filter must by
completely dry before re-fitting. Allow
filters to air-dry naturally.
4
Replace the filter and the front cover.
Changing the belt
If the power brush stops rotating it is
likely that the drive belt has snapped (usually
because the brush has been stalled). A spare
belt is supplied. Replacement belts can also
be obtained from Morphy Richards or a
Service Agent.
6
H
J
I
ı
ˆ
8537 Upright cyclone ib 12/05/2003 18:11 Page 6
