6
Upright vacuum cleaning
1
Turn the product on by pressing the upright
on/off button
(2)
.
When the product is turned on, the handheld
vacuum cleaner power indicator light
(16)
will
illuminate blue and the floorhead lights
(22)
will
illuminate.
NOTE: When the battery reduces to a pre-set
level the product will stop, the light will
extinguish and the product must be recharged.
Two power settings are provided. When
switched on, the unit will automatically start at
high power. By pressing the power selector
button
(3)
once, the power will drop to low.
Press the button a second time to switch the
power back to high (see diagram 2, above right).
Further presses of the power selector button will
toggle the power between low and high.
2
Using the product on low power will be sufficient
for light cleaning and will extend the running time
until the product needs to be recharged.
You can also turn the product on with the
handheld vacuum cleaner on/off button
(15)
.
Switching the power on using this button will not
run the rotating brush bar in the motorised floor
brush
(21)
.
NOTE: There are no variable power settings on
the handheld vacuum cleaner
(10)
.
Upright vacuuming: assembly
1
2
3
1
Swing the upright handle
(1)
on the main vacuum
cleaner upwards until it clicks into place in an
upright position.
2
Place the motorised floor brush
(21)
on a level
surface and align the connector on the neck of
the motorised floor brush with the connector hole
on the base of the main vacuum cleaner body
(11)
.
Holding the neck of the motorised floor brush in
place, lower the main vacuum cleaner body onto
the motorised floor brush until you hear the two
pieces click into place.
When attaching the motorised floor brush, ensure
that the latching mechanism is fully locked in
place to ensure electrical connection is made.
3
Fit the handheld vacuum cleaner
(10)
into the
cavity on the main vacuum cleaner body by firstly
sliding the suction end into place over the
suction hole in the main vacuum cleaner body
cavity, then push the handle end in to place until
a click is heard.
VC732102 MUK Rev1.qxp_Instruction Book 14/11/2016 09:28 Page 6