6
Setting the timer
1
To program the heat to turn on in 3
hours time, move the timer button to the
unfilled 3 symbol
. Ensure that the
heat setting is set to pre-heat, maximum
heat level.
2
When you get into bed, change the heat
level to low, all night level. The heat will
turn off after 9 hours, unless an
alternative timer off setting is selected.
3
To program the heat to turn off after a
set number of hours, move the timer
button to the filled hour symbol
⁄‹Â
.
For example, to set to turn heat off after
1 hour, move the button to the 1
⁄
.
Ensure that the heat setting is set to a
low, all night level.
• Note: The timer function will switch the
blanket off after the selected time. The
timer must be switched to the OFF
position before setting a further time.
Washing instructions
•
Do NOT dry clean
-
•
Do NOT iron
-
WARNING: Before washing ensure
that you detach all the controls from
the blanket.
•
Only use in a washing machine with a
drum large enough to take the blanket
without forcing it in.
1
Measure the blanket so it can be
stretched back to its original size whilst
wet.
Machine washing
1
Unplug the blanket from the power
socket.
2
Disconnect the control switch and cord
from the blanket by lifting the locking
lever over the raised button and pull
apart.
C
3
Wash on the WOOL setting at 40˚C.
4
Gently stretch the blanket back to it’s
original shape and size before line drying
WITHOUT using clothes pegs on the
wired area of the blanket. (See
instructions for tumble drying below).
Hand washing
1
Unplug the blanket from the power
socket.
2
Disconnect the control switch and cord
from the blanket by lifting the locking
lever over the raised button and pull
apart.
C
3
Use a mild washing liquid or detergent
and lukewarm water.
4
Immerse the blanket in the water and
allow to soak for 5-10 minutes.
5
Squeeze the soapy water through the
fabric.
6
Rinse the blanket thoroughly in cool
water, gently squeezing the fabric.
WARNING: Do not wring dry.
7
Gently stretch the blanket back to its
original shape and size before line drying
WITHOUT using clothes pegs on the
wired area of the blanket.
Tumble drying
1
Controls must be removed.
2
Gently stretch the blanket back to its
original shape before drying.
3
Tumble dry on the low heat setting,
following the manufacturers instructions
for the required drying time.
40º
C
S5 Rev 2 21/7/04 1:54 PM Page 6
