Morphy Richards IB73100, Инструкция по эксплуатации

Страница: 5 / 8

5
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Charging the battery
Your vacuum cleaner comes with the battery
fully assembled. The battery will be in a low
charge condition. It should be charged for 20-24
hours prior to initial use.
Note: Charging should not be carried out
when the ambient temperature is below 0
o
C or
above +40 o C.
The charging unit will become warm during
use. This is normal.
IMPORTANT: Do not charge for more than
72 hours as overcharging may damage the
battery. Do not allow the battery to completely
discharge. Low suction indicates a low battery.
Recharge the battery as soon as possible.
To Recharge
1
Slide the on/off switch to the off position.
2 Insert the connector plug from the end of the
charging unit
into the charging socket
on the cleaner.
3 Plug the charging unit into the electrical
socket, the LED charging indicator
will
light up. This indicates that the unit is
charging correctly.
When the battery is fully charged the LED
indicator will go off.
4 Remove the charger unit from the electrical
outlet socket then remove the connector plug
from the cleaner.
IMPORTANT: Do not use the cleaner with the
charger unit connected.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Controls
1 Slide the on/off switch downwards to turn
the unit on.
2 Slide upwards to switch the unit off.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Dry pick up
1 Disconnect the unit from the charging
adaptor
.
2 Slide the on/off switch downwards to turn the
unit on.
3 When picking up dry debris, vacuum in any
direction until the area is clean. For heavily
soiled areas, a backwards and forwards
sweeping motion should be used. A brush
attachment is included for cleaning the
carpet.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Wet pick up
Empty the container before picking up liquid
or wet debris.
1 Do not suck in liquid above the ‘FILL LINE’
marking. Handle with care when you have
liquid inside the tank.
IMPORTANT: Keep the water away from the
tank cover/motor unit as this could damage the
unit.
2 After use rinse the tank and filter in warm
water (no detergent) and thoroughly dry
before re-assembly.