Operation
Please remember that the steam cleaner
operates by emitting steam at an increased
temperature of 130˚C. Never use it on
objects or surfaces which cannot resist this
temperature, delicate materials, dralon,
plastic, natural fur etc. Where any doubt
exists check carefully on a part of the
material where minor marks will not matter.
WARNING: Always switch off, unplug
and release all steam using the steam
trigger before opening and removing the
filler cap.
Filling the boiler
Ensure steamer is unplugged from the
socket before filling or re-filling.
1 Unscrew the filler cap
⁄
by pressing
down and turning anti-clockwise.
2 Fill the boiler with a maximum of 1.4
litres of water by using the jug
provided and funnel. Warm water may
be used which will reduce heat up
time. Do not use any detergent.
3 Refit the filler cap and fully tighten by
pressing down and turning clockwise.
IMPORTANT: The water tank should be
emptied after use.
IMPORTANT: Allow the water tank to dry
out before replacing the cap.
Re-filling the boiler
WARNING: Always switch off, unplug
and release all steam using the steam
trigger before opening and removing the
filler cap.
1
Before opening the filler cap to refill the
tank, release the steam pressure by
pressing the steam trigger
Â
on the
handle. Press until all the steam has
been expelled from the tank or allow the
cleaner to cool down completely.
2
Follow ‘filling boiler instructions’ to refill.
WARNING: Even after the unit has
cooled for 5 minutes the remaining water
in the tank and the filler cap will be very
hot and can cause burns.
WARNING: The use of any other fluids
can be dangerous and can lead to
damage of the heating element.
WARNING: The filler cap must never
be opened during use.
Recommendation: The use of distilled
water is recommended especially in hard
water areas in order to prevent limescale
build up and to prolong the working life of
the cleaner.
5
70530 Rev 4 2/6/04 2:53 PM Page 5