6
Emptying and storing
When you have finished ironing unplug your
iron. Ensure that the steam button is in the
‘Steam off’ position and empty any remaining
water out of the filler hole
I
. Remember to
replace the water tank cap before storing.
Do not store in the box, but in an upright
position, so that any drops of water remaining
cannot leak out and discolour the soleplate. Your
iron has a cable tidy feature.
Important: The flex can be
damaged if wound too tightly
around the iron after use. Make
a loose loop with the flex and
wrap it around the iron using
the cord clip to keep the flex in
place. The iron must be cool
before winding the flex and
storing on its heel
J
.
Maintenance
Jet cleaning
Shot of Steam models have a built in cleaning
system designed to keep the water tank, water
valve, steam chamber and steam vents clear of
lint and loose mineral deposits. The ‘Jet Clean’
should be operated after each period of ironing.
To operate - ensure there is a little water in the
tank, place the iron on its heel. Having turned the
temperature control dial to its maximum
position, wait for the indicator light to go out,
then unplug the iron and hold it about 6"
(150mm) above the sink in the ironing position
and push the shot of steam button
G
about 10
times in succession. After this cleaning operation,
empty out any remaining water.
To clean an aluminium soleplate
To keep the soleplate of your iron clean and
free of limescale, make a paste of mild scouring
powder and a little water. Apply a small amount
to the soleplate, rub and then remove with a
damp cloth. Wipe thoroughly with a clean cloth.
To clean a mirror finished soleplate
If your iron has been fitted with a polished or
mirror finished soleplate for easier ironing please
follow the cleaning instructions below:
To keep the soleplate of your iron clean and
free of limescale we recommend that you use
one of the gentle chrome or silver cleaners
generally available, and always follow the
manufacturers instructions on the container. To
clean off melted on man-made fibre set the iron
to the 3 dot position and pass it over a clean
piece of cotton which will draw the deposit off
the surface.
To clean a coated soleplate
In the unlikely event of any man-made fibre
fusing to the soleplate set the iron at the 3 dot
position and pass it over a clean piece of cotton
which will draw the deposit off the surface.
Do not use scouring powder or solution
as this could damage the coating.
To clean the exterior
Allow to cool and wipe over with a damp
soapy cloth, then dry with a clean dry cloth.
Morphy Richards Limited, Mexborough,
South Yorkshire, England S64 8AJ
Morphy Richards products are intended for household use only.
Morphy Richards has a policy of continuous improvement in product quality and design.
The Company, therefore, reserves the right to change the specification of its models at any time.
441/3752/06 Rev 3
J
I
