Emptying and storing
When you have finished ironing,
unplug your iron. Ensure that the
steam control
fl
is set to the 'off'
position. Remove the water inlet
cover and empty any remaining water
out of the filling hole. Replace the
water inlet cover.
Ensure the iron is cool and
thoroughly dry before storing in the
bag provided.
IMPORTANT: The flex can be
damaged if wound too tightly around
the iron after use. Make a loose loop
with the flex and wrap it around the
iron. The iron must be cool before
winding the flex and storing on its
heel.
Jet cleaning
Your iron has a built in cleaning
system designed to keep the water
valve, steam chamber and steam
vents clear of lint and loose mineral
deposits. The ‘jet clean’ should be
operated after each period of ironing.
To operate, ensure that there is a
little water in the tank, place the iron
on its heel and turn the temperature
control dial to the 3-dot setting. Wait
for the temperature indicator light to
go out, then unplug the iron and hold
it 6'' (150mm) above the sink in the
ironing position. Push in the surge
button about 10 times in succession.
After this cleaning operation, empty
out remaining water.
WARNING: Do not use
descaling products in this iron.
To clean a coated soleplate
In the unlikely event of any man-
made fibres fusing to the soleplate,
set the iron at the 3-dot position and
pass it over a clean piece of cotton
which will draw the deposit off the
surface.
Do not use scouring powder or
solution as this could cause damage
to the coating.
To clean the exterior
Allow the iron to cool and wipe
with a damp cloth, then dry.
Helpline
If you have any difficulty with your
appliance, do not hesitate to call us.
We are more likely to be able to
help than the store from where you
bought it. Please have the following
information ready to enable our staff
to deal with your query quickly.
•
Name of the product
•
Model number as shown on the
underside of the appliance.
7
41540 Rev 1 1/6/04 12:00 PM Page 7
