Important safeguards
Important safeguards
Important safeguards
Important safeguards
Important safeguards
When using your iron, basic safety
precautions should always be followed,
including the following:
1
Read all the instructions.
2
Use the iron only for its intended
use.
3
To protect against the risk of
electric shock do not put the
appliance in water or in any other
liquid.
4
Close supervision is necessary
when any appliance is used near
children. NEVER ALLOW A CHILD
TO USE THIS PRODUCT.
5
The socket should always be off
before plugging or unplugging from
the socket. Never yank the cord to
disconnect from socket, instead,
grasp plug and pull to disconnect.
6
Do not allow cord to touch hot
surfaces. Let iron cool completely
before putting away. Loop cord
loosely around the iron before
storing.
7
Always disconnect the iron from
the electrical socket when filling
with water or emptying and when
not in use.
8
Do not use outdoors.
9
Do not operate the iron if it has a
damaged cord or if the iron itself
has been dropped or damaged. To
avoid the risk of electric shock,
do not disassemble the iron, but
telephone Morphy Richards for
advice. Incorrect reassembly can
cause a risk of electric shock
when the iron is used.
10 Do not use the vertical steam
feature on clothes that are being
worn.
Special instructions
Special instructions
Special instructions
Special instructions
Special instructions
1
If your iron does not work, check
the following points: Has the
temperature control been set to the
required temperature? Is the plug in
its socket? Is the plug itself or the
socket faulty?(Check by plugging in
another appliance).
2
Warning : When not in use, your
iron should never be placed flat
and left on an ironing board.
3
To prevent damage to the textile
being ironed, follow the tempera
ture guide carefully. (Test on the
inside hem of the garment).
4
When ironing is complete, remove
the plug from the socket, empty
any remaining water from the tank,
and allow to cool before storage.
5
If you drop or severely knock
your iron this could cause internal
damage even if the outside appears
alright. Have it checked by a
qualified electrician.
SAVE THESE INSTRUCTIONS
SAVE THESE INSTRUCTIONS
SAVE THESE INSTRUCTIONS
SAVE THESE INSTRUCTIONS
SAVE THESE INSTRUCTIONS
11 Do not leave the iron unattended
whilst plugged in or on an ironing
board. Never allow the mains lead to
over hang the work surface.
12 Burns can occur from touching
hot metal parts, hot water or steam.
Use caution when you turn a steam
iron upside down, there may be hot
water in the water tank.
3
6
4
Always pour out the remaining
water after use.
WARNING :
When filling your iron with
tap water always use the
beaker provided. Never fill
directly under the tap.
Temperature control
Temperature control
Temperature control
Temperature control
Temperature control
Plug in the iron and switch on. Set
the temperature control dial
to the
temperature required, but don’t start
ironing immediately. If you wait a few
minutes, the iron will stabilise at the
required setting.
It is always a good idea to begin
with ‘cool’ fabrics and work up to
higher settings. An iron heats up
quicker than it cools down so you’ll
save time and electricity.
Features of your iron
Features of your iron
Features of your iron
Features of your iron
Features of your iron
Temperature indicator light
The indicator light
shows that
the iron is warming up. When the
required temperature is reached the
light will go out and will cycle on-off
during operation. This shows that the
iron is maintaining the heat setting
you have chosen.
Dry ironing
You can also use your iron as a
dry iron only. Make sure the steam
control
is set to the
symbol.
Any temperature setting may be
used depending on the garment. You
do not need to put any water in the
tank when dry ironing only.
Steam control
Fill the iron with water as
described in “Filling”, (page 5) and
insert the plug into the electrical
socket.
Turn the temperature control dial
, to the “steam” position shown as
and rest the iron on it’s heel
whilst it warms up.
Turn the steam control
to the
steam position.
.
The steam facility should only be
used on garments which are suitable
for ironing at the 3 dot setting.
