Voyager travel iron
The After Sales Division, Morphy Richards Ltd, Mexborough,
South Yorkshire, England, S64 8AJ Helpline (office hours)
:UK (local rate) 08450 777700, Republic of Ireland 1800 409119
Maintenance
Maintenance
Maintenance
Maintenance
Maintenance
Jet Cleaning
Your iron has a built in cleaning
system designed to keep the water
valve, steam chamber and steam
vents clear of lint and loose mineral
deposits. The ‘jet clean’ should be
operated after each period of ironing.
To operate, ensure that there is
little water in the tank, place the iron
on its heel and turn the temperature
control dial to the maximum setting.
Wait for the temperature indicator
light to go out, then unplug the iron
and hold it 6’’ (150mm) above the
sink in the ironing position. Push in
the steam control about 10 times in
succession. After this cleaning
operation, empty out any remaining
water.
To clean a coated soleplate
In the unlikely event of any man-
made fibre fusing to the soleplate, set
the iron at the 3 dot position and pass it
over a clean piece of cotton which will
draw the deposit off the surface.
Do not use scouring powder or
solution as this could cause damage to
the coating.
To clean the exterior
Allow the iron to cool and wipe over
with a damp cloth and mild detergent,
then dry with a dry cloth.
Morphy Richards products are intended for household use only.
Morphy Richards has a policy of continuous improvement in product quality and
design. The Company, therefore, reserves the right to change the specification
of its models at any time.
Morphy Richards Limited, Mexborough,
South Yorkshire, England, S64 8AJ
441/3752/21 Rev 1
Includes World Wide Travel Adaptor
World Wide Travel Adaptor
The world wide travel adaptor converts UK plugs to foreign sockets in seconds.
The adaptor consists of both a continental adaptor plug for travel within Europe
and a trans-continental adaptor plug for use in North/South America, Japan, Far
East and Australia.
Attention
It is not suitable for use in all countries.
