8
1.
Firstly assemble the Driving Shaft
(6)
into the Motor
Base
(7)
, make sure it is locked into position.
2.
Place the Bowl
(5)
on the Motor Base
(7)
from the
unlock position and turn the Bowl
(5)
until it is
locked into place. Ensure it is assembled in place
correctly; otherwise the appliance will not operate.
3.
Fit the Shredding Blade
(11)
, Slicing Blade
(9)
or
Chipping Blade
(10)
(Coarse or fine) into the Blade
Holder
(12)
.
Note: For assembling the Blade
(9, 10, 11)
into the
holder. First hook the tab on the Blade in into the
Blade Holder
(12)
at the left hand side, then press
down on the right hand side of the Blade
(9, 10,
11)
to securely lock into place. Failure to corrctly
fit the Blade
(9, 10, 11)
could cause damage to
the appliance.
4.
Place the assembled Blade Holder
(12)
with chosen
Blade
(9, 10, 11)
onto the Drive Shaft
(6)
and press
down fully.
5.
Place the Jug Lid
(14)
onto the Bowl
(5)
and turn it
clockwise until it locks into place. Make sure it is
locked in position correctly, otherwise the appliance
will not operate.
6.
Turn the Speed Dial
(8)
to setting 1 for soft chopping
or setting 2 for harder chopping.
7.
Use the food pusher
(1)
to feed the food into the
Feeding Funnel
(2)
. Cut the food to size so it can be
put into the Feeding Funnel
(2)
. You can slice up to
1kg of food at one time.
Caution: Minimum 2 minute rest periods must be
maintained after each one minute operation
cycle. At least 30 minutes rest period must be
maintained to let the appliance cool down after
three separate operational cycles
8.
Turn the Speed Dial
(8)
to the “0” position and
unplug from the power socket after processing.
Remove the Blade Holder
(12)
unlock the Bowl
(5)
by
turning it anti-clockwise and lift it off. Empty the
processed food.
1.
Disconnect from the power socket before cleaning.
2.
Immerse the Bowl
(5)
, Lid
(3)
, Food Pusher
(1)
and
Shredding
(11)
, Slicing
(9)
or Chipping
(10)
Blade in
warm soapy water and clean with the aid of a cloth
or soft brush. Then dry thoroughly.
Caution: Care must be taken when handling the
blades as they are very sharp.
Note: For dissasembling the Blade
(9, 10, 11)
from the Blade Holder
(12)
turn the holder upside
down. Press the Blade on the opposite side to
the tab until it is released.
3.
Wipe the outside of the Motor Base
(7)
with a damp
cloth. Never immerse the Motor Base
(7)
in water.
Then dry thoroughly.
Note: Some food may discolour the Blade Holder
(12)
, this is normal and will not harm the plastic
or affect the flavour of the food. Rub with a cloth
dipped with vegetable oil to help remove some
discolouration.
Slicing/Chipping/Shredding
Cleaning After Slicing/
Chipping/Shredding
Tab
FP401013 MUK REV 1.qxp_Layout 1 01/02/2018 10:41 Page 8
