• Removing:
First remove the plug from the power
socket, before releasing the flexible
hose firmly from the air intake duct.
To release, squeeze the clips either
side and pull.
2. Fitting the extension tubes and
accessories
.
a) Assemble the combination floor
tool, telescopic tube and hose as
shown. To extend the telescopic
tube to the required length, push the
slider release and pull out the tube.
b) Attach your choice of floor tool to
the telescopic tube.
Floor tool:
Ideal for daily cleaning of carpets
and hard floors, such as wood, lami-
nate, tile and vinyl flooring.
Crevice tool:
For awkward places, ie. behind ra-
diators, corners, baseboards and
between cushions.
Round brush:
Used for furniture, venation blinds,
books, lamp shades and shelves.
Small brush:
Used for curatins and upholstery.
INSTRUCTIONS FOR USE
• Before using appliance, un-
wind sufficient length of cable
and insert the plug into the
power socket. A yellow mark
on the power cable shows
the ideal cable length. Do not
extend the cable beyond the
red mark.
• Press the on / off button to
switch the appliance on.
Eco switch:
A variable Eco switch varies the suc-
tion power as required. For example,
maximum suction can be used for
cleaning carpets, hard floors etc.
and reduced suction for cleaning
upholstery and curtains.
Suction can also be controlled us-
ing the airflow regulator on the hose
handle. Closed for maximum suc-
tion, open for reduced suction.
Automatic cable rewind:
Afer use, unplug and press the cable
rewind switch to retract the cable.
Emptying the dust bag:
To obtain the best from your cleaner,
change the dust bag regularly. other-
wise the airflow and cleaning power
will be reduced.
NOTE: If you forget to attach the dust
bag or attach it incorrectly, the dust
cover may not close properly.
1. Remove the flexible tube, and open
the front cover.
2. Pull clip backwards to unsecure the
dust bag.
3. Remove the dust bag.
4. Replace the dust bag when it is full
of dirt and put in a new one.
5. Close the cover by pressing down
until it clicks into place.
Cleaning the filter:
The filter should be cleaned at least
twice a year, or when it becomes vis-
ibly soiled. A clogged filter will result in
reduced suction or even motor dam-
age.
Always operate the cleaner with the
filter installed.
Disconnect from the electrical outlet
before cleaning the filter.
Do not use a washing machine to rinse
the filter.
Do not use a hairdryer to dry it.
1. Pull the dust bag upward.
2. Pull the filter supporter upwards.
3. Remove the filter.
4. Rinse the filter in lukewarm water
and dry it completely.
5. Put the filter back.
Changing the HEPA filter:
1. Open the cover for the HEPA filter by
unclipping the cover.
2. Use both fingers to pull out the
HEPA filter by pulling upwards.
71600SA_IM revised_4NOV2010.indd 4
71600SA_IM revised_4NOV2010.indd 4
2010/11/08 08:49:45 AM
2010/11/08 08:49:45 AM