4
1
Using the iron
1) Filling the tank
Before first use, remove all packaging, including the protective cover on the soleplate. Make sure the iron
is not plugged in. Set the steam switch
(7)
to off. Fill the water tank
(17)
via the filling hole
(13)
. To fill the
tank with the maximum amount of water, we recommend the iron is tilted vertically whilst being filled.
WE RECOMMEND THE USE OF DISTILLED, DEIONISED OR DEMINERALISED WATER.
Never use battery topping up fluid or water containing any substances like starch, sugar, fragrant
additives or defrosted water from a refrigerator.
NOTE: Please see point 2 of ‘Exclusions’ on page 8.
Plug in the charging base
(10)
and switch on at
the mains. The charging base power light
(8)
will
illuminate.
Rest the iron on its heel
(5)
on the charging base,
ensuring that the heel connector
(6)
meets the
charging base connector
(9)
. Connection is made
when the power indicator light
(3)
on the handle
illuminates. Wait until the iron reaches the desired
temperature (see step 3), then commence ironing.
Throughout your ironing session, the iron
must be replaced onto the charging base
every few seconds or whenever you adjust
your garments, to keep the heat topped up.
Set the temperature dial
(16)
to the temperature
required (see ‘Temperature Guide’ on page 3).
The temperature indicator light
(4)
will
illuminate red until the required temperature is
reached, then it will turn green.
NOTE: It is normal for the temperature indicator
light to flicker between red and green whilst the
temperature cycles up and down during charging.
Tip: We recommend the temperature indicator
light is allowed to cycle red and green twice
before you begin ironing.
The temperature indicator light and the power
indicator light will switch on and off whilst you are
ironing and replacing the iron on the base.
Tip: Begin with cool fabrics and work up to higher
settings. An iron heats up quicker than it cools
down so this will save you time and energy.
If required, switch on the steam using the steam
switch
(7)
.
The amount of steam is automatically adjusted
to suit the temperature selected.
For stubborn creases, use the water spray
button
(1)
.
If using for the first time, you may need to press
this a few times to pull the water through.
2) Charging base
3) Temperature Selection
4) Switching on the steam
5) Using the water spray
RN303250MUK Rev1.qxp_Instruction Booklet 31/01/2019 10:54 Page 4
