5
www.goblin-vacuums.com
Using on carpets
1
Place the cleaner in its upright
position.
2
Set the floor nozzle height
adjustment dial
·
to the
desired position.
3
Release the mains cable by
revolving the quick release cleat
Ë
half-a-turn and extend the
cable fully.
4
Plug the cable into the mains
socket.
5
Step on the upright release
pedal
Ì
to release the vacuum
to the desired position.
6
Press the ON/OFF button to the
‘ON’ position.
IMPORTANT: To prevent
damage to carpets:
•
Never leave the cleaner
switched on in one place for an
extended period.
•
Never have the brushes set too
low such that the cleaner is hard
to push.
•
Never lean on the product.
Using the
attachments
1
Follow steps
1
-
4
of the ‘Using
on carpets’ section, but set the
floor nozzle height adjustment
dial to the tools setting.
2
Attach the accessories
‚ „ ‰
to the handle, removing the
handle from the telescopic tube,
then firmly push on the desired
accessory
F
:
Turbo nozzle
‚
(certain
models only) is ideal for pet hair
removal from stairs and
upholstery.
Upholstery tool
„
for
upholstery, stairs etc.
Dusting brush
„
for delicate
surfaces.
Crevice tool
‰
for awkward
places, corners and behind
radiators etc.
3
If additional length is required,
remove the telescopic tube from
the cleaner, connect it to the
handle, and add the desired
accessory to the end of the tube
G
.
4
Switch ON.
•
IMPORTANT: When using the
hose and tools, locate the hose
into the hose hook
Ï
on the
main unit. This will help prevent
the cleaner from tipping over.
•
IMPORTANT: Turning the cleaner
sideways helps prevent the
cleaner being pulled along by
the stretched hose.
Using & cleaning the
turbo nozzle
(certain models only)
Attach the Turbo nozzle to either
the handle or the telescopic
tube as described previously.
Following use, your turbo nozzle
may become clogged. Switch
the cleaner to ‘OFF’ and detach
the tool. Turn over the tool and
pull away any hairs or fibres. If
they are tightly wound around
the brush, carefully snip the
fibres with scissors, being
careful not to damage the brush
bar, pull away from the brush
bar and dispose.
SAFETY CUT-OUT
If the cleaner overheats, a motor
protection thermostat will
automatically switch the motor
off. If this happens,
switch the
cleaner off, unplug from the
power supply and leave the
cleaner to cool for at least 60
minutes
. Check the airways for
blockages, empty the dust
canister and clean the filters
before restarting.
F
G
VC73285MUK Rev2:VC73285MUK Rev2 19/01/2010 09:40 Page 5
